Toggle Switches and Radio Control Knobs

[18usc371]

This guy custom 3d prints replacement toggles might contact him. https://www.shapeways.com/shops/s550parts
.

Also, I ***think*** these are for BASE model button to toggle conversions = 3 button to 3 toggle, not 4. If so, too wide.

"This toggle assembly will completely replace your boring factory buttons for hazard, traction control, and steering mode"

Sponsored

 

[SpectreGadget]

I know what you are saying, but I've never broken down the bezel that far to know if they are on their own panel (that's not my photo) and if what you suggest would work. I'm no fan of the chrome, but if I swapped to GT350 switches which display on their face a different function that what the actual did on a GT/EB, it would bother me as much as the chrome. But that's just me . . .

I agree. I'd like to explore this, but at this point, I'm not ready to tear apart my two week old car. yet.

 

[drjeff]

The GT350 toggles do not perform the same functions as the GT/EB toggles

what’s the difference?

 

[18usc371]

what’s the difference?

From Left to Right:

GT350

Hazard - Traction Control - Launch Control - Exhaust Mode (normal/sport)

EB/GT:

Hazard - Traction Control - Steering (3-modes) - Drive Modes (rotates through 5?? modes)

On the GT350, the steering modes and drive modes are accesses through a button on the steering wheel.

 

[djcwardog]

I’ve got the Scosche 8” aftermarket radio kit. Their center bezel comes with a plate and a circuit board for each of the 3-button (as delivered in my base GT) and the 4-button toggles. I installed my 3-button switch assembly and it works as intended. However, I’d like to find an OEM 4-button toggle switch to swap in and obtain a drive mode switch that way. Anybody got a part number and/or the piece itself for this? By the way, I also have a 401a digital dash retrofitted but I’m not yet able to find a menu to switch drive modes. The closest found so far is to allow the digital cluster display to change with drive modes.

 

[opengl]

By the way, I also have a 401a digital dash retrofitted but I’m not yet able to find a menu to switch drive modes. The closest found so far is to allow the digital cluster display to change with drive modes.

You can't switch drive modes via the 401A cluster, it has to be done with the mode switch.

 

[djcwardog]

Thanks for confirming - so it must be a hardware swap.

Sponsored