P1X Pulley size recommendations

[80FoxCoupe]

I’m about to try a 4.25 and Procharger recommended a K080653. Currently have a K080660 with a 4.5 and is in the middle travel at the recommended tension

653 wont work with 4.25, try it and find out.

Sponsored

 

[sloride]

653 wont work with 4.25, try it and find out.

Yeah I’ll give it a shot. Belt was already delivered. If no good I’ll send it back. Thanks.

 

[Toy Cobra]

Yeah I’ll give it a shot. Belt was already delivered. If no good I’ll send it back. Thanks.

I would send it back and get the recommended size for sure.

 

[sloride]

I would send it back and get the recommended size for sure.

Procharger techline is the one that recommended it unless he screwed up on his end

 

[Toy Cobra]

Procharger techline is the one that recommended it unless he screwed up on his end

In that case you should be good to go!

 

[80FoxCoupe]

Procharger techline is the one that recommended it unless he screwed up on his end

So does it fit??

 

[sloride]

So does it fit??

Haven’t tried yet. Might get a chance tomorrow.

 

[sloride]

So does it fit??

Nope it didn’t fit. Threw on my 660 belt so I could cruise and get some gas. Tensioned up just on the bottom side of half. Will send this back and try a 655 to hopefully put me in the middle

 

[80FoxCoupe]

Nope it didn’t fit. Threw on my 660 belt so I could cruise and get some gas. Tensioned up just on the bottom side of half. Will send this back and try a 655 to hopefully put me in the middle

655 will run with maximum belt wrap on a 3.77 pulley. Which is where I like to run.

 

[sloride]

655 will run with maximum belt wrap on a 3.77 pulley. Which is where I like to run.

My 660 on 4.25 has good wrap now may just stick with it. Thoughts on attached photo at proper tension

 

[80FoxCoupe]

That's fine, I've ran it deeper with no issues

 

[sloride]

That's fine, I've ran it deeper with no issues

Cool thanks. I’ll just roll with it for now.

 

[TorresDoe8]

Cool thanks. I’ll just roll with it for now.

That's fine, I've ran it deeper with no issues

Where's everyone gettin their RPM belts? Can't seem to find any in stock

 

[80FoxCoupe]

I get mine at my local NAPA. They are typically made to order and take a few days to get.

 

[SolarFlare]

My 660 on 4.25 has good wrap now may just stick with it. Thoughts on attached photo at proper tension

Id say that's looks good. Im near max with that belt and a 4.13

Sponsored