who's running E85 tune and has 1/4 times?

[DLOH]

I Had a 2020 GT PP1 with only a few mods- closed cold air box, resonator delete + catback, drag pack wheels & tires and a E85 Mak Performance Tune. I made 10 passes at the NMRA event in Bradenton and had times between 11.57- 11.79.

anybody running similar times? or are they a little slower because of the weight of the Mach 1?

Let me know who's tune you have and if you have any other mods.

Sponsored

 

[Dinokill3.7]

2017 GT 6 speed manual with E85 and catback exhaust.

Horrible launch because I have regular street tires and my best was 12.6.

I will assume I can go as low as 12.00 with a drag pack

Tuned by Lund. Also in Bradenton.

 

[NHMach1]

I ran 11.76 at 119 with E85 tune from Livernois and drag radials. A10

 

[NGOT8R]

2019 Bullitt (with magneride), LTHs, x-pipe, axle back, Stop the Hop Kit, ET Street Rs, Lund tuned on E85 by Brandon. Passes made at Bradenton also.

My clutch was slipping on this 12.30 pass (could hear and feel it). I’ve since pulled the clutch and here is what it looks like with 6K miles on it. I was running a Clutch Hitmaster (Clutch Hit Control System) at the time which was also improperly adjusted. I’ll have to get that sorted out with the new clutch that’s going in, because I want to stick with this system.

 

[DLOH]

@NGOT8R I almost got funny/mean but I see that you were having some problems. You going to Orlando this year?

@NHMach1 11.76 nice job. looks like I am going to need some LTH's or some great weather to match my GT times.

Here are my time slips.

 

[NGOT8R]

@DLOH, no worries. Yeah, I was definitely having a whole lot of trouble with my setup and it was very frustrating to say the least. I’ll be back up and running soon and more determined than ever to run some ETs that are in line with what the car should be capable of. I won’t be at Orlando though.

 

[NGOT8R]

@NGOT8R I almost got funny/mean but I see that you were having some problems. You going to Orlando this year?

@NHMach1 11.76 nice job. looks like I am going to need some LTH's or some great weather to match my GT times.

Here are my time slips.

Those are nice ETs btw. That’s more in line of what I was hoping to run on motor and 10.60-10.80 with nitrous. Those autos have great mph too (always 4-5 mph higher than a manual).

 

[NHMach1]

Thanks! Same to you! Here are some of my slips. I bet in better air could have run in the 11.60s or maybe high 11.50s. Going again in a few months. I've lost 97 lbs since then, weight = Horsepower lol. Hopefully get some mineshaft air too. Good luck to you!

 

[DLOH]

@NHMach1 Your results are encouraging . What tire are you running? The 60' of 1.85 can be greatly improved. Mine was 1.71 Not sure if that is weight difference, tire or tuning?? subtract the .14 on the 60" and add the same to the big end and you are at 11.48. Not that would be nice.

 

[DLOH]

@DLOH, no worries. Yeah, I was definitely having a whole lot of trouble with my setup and it was very frustrating to say the least. I’ll be back up and running soon and more determined than ever to run some ETs that are in line with what the car should be capable of. I won’t be at Orlando though.

I hope all goes well!! Get her repaired and get to Orlando!! Yes, the a10's are legit.

 

[Proshop]

I hope all goes well!! Get her repaired and get to Orlando!! Yes, the a10's are legit.

When is Orlando?

 

[NHMach1]

275/40/18 Nitto 555RIIs 26.7 tall. Didn't want to over tire it. They hooked great
Yeah that would be awesome.

 

[DLOH]

When is Orlando?

NMRA first week of March 2023. They moved it from Bradenton. Great event. We rent an RV and stay on site. We go from Thursday to Sunday.

 

[Proshop]

NMRA first week of March 2023. They moved it from Bradenton. Great event. We rent an RV and stay on site. We go from Thursday to Sunday.

Sweet! I’ll definitely have to make it especially since I live 45 mins away.

 

[Coyote Chase]

Did you guys make it to the NMRA Spring Break Shootout at Orlando Speed World??
What class are you running?

Sponsored