Trans and Clutch

[JFit_5.0]

Hey guys new to this forum. Wondering if anyone can answer this question. Can a 2018 dual clutch be used on a 2015 MT82? Reason why is because I own a 2018 5.0 PP1 and my stock MT82 has been fixed twice because of fork shifts and what not. I have a buddy that has a 2015 MT82 laying around with less than 10k miles and short shifter. And wondering if it'll fit my 2018.

Sponsored

 

[I Bleed Ford Blue]

Mechanically, it will bolt in, same shifter, driveshaft, etc. The 18's did not not have rev matching so the plugs and wiring should be the same. Just get a new clutch for when you do the swap, also get a blowfish racing shifter support bracket or a combination bracket/shifter from barton racing. The support backet will greatly improve the shift feel and longevity of the trans.

On a side note, the 15-17 trans will improve your 0 to 60 times. The 11-17 MT-82's were close ratio with a single overdrive with 5th gear being 1:1.
In 18 ford changed the trans to a wide ratio gear set with a double overdrive and now 4th gear is 1:1

 

[JFit_5.0]

Mechanically, it will bolt in, same shifter, driveshaft, etc. The 18's did not not have rev matching so the plugs and wiring should be the same. Just get a new clutch for when you do the swap, also get a blowfish racing shifter support bracket or a combination bracket/shifter from barton racing. The support backet will greatly improve the shift feel and longevity of the trans.

On a side note, the 15-17 trans will improve your 0 to 60 times. The 11-17 MT-82's were close ratio with a single overdrive with 5th gear being 1:1.
In 18 ford changed the trans to a wide ratio gear set with a double overdrive and now 4th gear is 1:1

Thank you sir very much appreciated !

 

[JFit_5.0]

Mechanically, it will bolt in, same shifter, driveshaft, etc. The 18's did not not have rev matching so the plugs and wiring should be the same. Just get a new clutch for when you do the swap, also get a blowfish racing shifter support bracket or a combination bracket/shifter from barton racing. The support backet will greatly improve the shift feel and longevity of the trans.

On a side note, the 15-17 trans will improve your 0 to 60 times. The 11-17 MT-82's were close ratio with a single overdrive with 5th gear being 1:1.
In 18 ford changed the trans to a wide ratio gear set with a double overdrive and now 4th gear is 1:1

You think I can still use the stock 2018 clutch meanwhile I get a new clutch?

 

[bauern]

You'll need to compare the input shafts. The pilot bearing is in the flywheel of the '18, while it is in the crankshaft of the 15-17.

 

[JFit_5.0]

You'll need to compare the input shafts. The pilot bearing is in the flywheel of the '18, while it is in the crankshaft of the 15-17.

Okay yeah makes sense. Thanks again

Sponsored