Lightning Struck
Well-Known Member
- Thread starter
- #1
I saw on Lethal's site that you have to uninstall Magnaride with a T56 swap. Can someone explain why?
Sponsored
There is a 6 pin sensor on the side that is tied into the magneride fine tuning.. as stated previously. It will throw codes and limit the car to 80 mph if not deleted.So MagneRide is tied to the transmission too? Doesn't make sense to me. Tied to speed yes, but it shouldn't matter if you're in 2nd, 3rd, or 4th gear, no? Don't see the relevance. Somebody please enlighten me on that .
That is 19+. 18's don't have it. (used for rev matching primarily)Look for this on the left side of the transmission, *way* up high. The '19 service manual wiring shows it, interesting if the '18s also have it.
Can it be modified to accept that 6 pin sensor?There is a 6 pin sensor on the side that is tied into the magneride fine tuning.. as stated previously. It will throw codes and limit the car to 80 mph if not deleted.
No, it cannot. It is a required feedback to PCM and will go into limp mode if not plugged in and reading properly.Can it be modified to accept that 6 pin sensor?