Procharged w/fuel system running E85, how to safely pulley down and switch to 93?

[K4fxd]

Also last night I drove it for about 30 miles total both street and freeway driving and it’s 36 degrees it didn’t go over 195 I hope that’s warm enough. I’m gonna order that lube thanks.

That is water temp. I am talking about oil temp. But even 195 will get rid of contaminates unless it is only for a mile or 2.

Warm it up and don't over think it. The lube is not 100% necessary either, just peace of mind. It does have 15 or more % gas.

Sponsored

 

[Unas2k5]

That is water temp. I am talking about oil temp. But even 195 will get rid of contaminates unless it is only for a mile or 2.

Warm it up and don't over think it. The lube is not 100% necessary either, just peace of mind. It does have 15 or more % gas.

Ok I see and the temperature I mentioned was cylinder head temperature I’ll just leave it as is and get that lube.

 

[SolarFlare]

That’s good to hear. How about your injectors & spark plugs are they fine this whole time ? Also I’m gonna order a horoscope Amazon has them pretty cheap. Good tool to have in my garage.

yes. Whenever I clean the injector they’re basically only lacking 2-3% flow

 

[5.0_Lojos]

4.25 pulley 10 psi

Your 4.25 is giving you 10 psi? I had a thread going where I was convinced, and with good reason to pulley down. I will be receiving my 4.25 soon. I went from a 4.74 to a 4.63 amd it was just a wa$te... Lookin forward to a bit more rowdiness 10 psi is where I should be at on pump 93 and Im cool with that.

 

[Unas2k5]

Your 4.25 is giving you 10 psi? I had a thread going where I was convinced, and with good reason to pulley down. I will be receiving my 4.25 soon. I went from a 4.74 to a 4.63 amd it was just a wa$te... Lookin forward to a bit more rowdiness 10 psi is where I should be at on pump 93 and Im cool with that.

Yes but each car is a little different

Sponsored