Porting stock intake

[Bill88stang]

Has anyone done there's or had here stock intake ported? I was wondering if they did the ports since of the cmcr flaps are part of the port basically once wide open.

Sponsored

 

[Grimace427]

http://www.mustang6g.com/forums/showthread.php?t=39117&highlight=porting+intake

 

[V8EATR]

I have a ported stocker for sale if you are interested.

 

[Bill88stang]

Looks like no one really touches the ports on these intake since the cmcv are part of it. So I'll prolly just clean up around the injector bump and port the opening for throttle body and clean up the edges and smooth it out.

 

[V8EATR]

Looks like no one really touches the ports on these intake since the cmcv are part of it. So I'll prolly just clean up around the injector bump and port the opening for throttle body and clean up the edges and smooth it out.

That's basically what I did.

 

[Bill88stang]

Have any pics of how it came out? So you didn't touch the ports except for the injector bumps basically?

 

[V8EATR]

Have any pics of how it came out? So you didn't touch the ports except for the injector bumps basically?

I probably have pics somewhere but I'd have to dig for them. I just cleaned up the casting flash, knocked down the injector bosses a bit and got rid of some material on the tb side (there was this block shaped piece near the evap port that I removed).

 

[BMR Tech]

I cleaned up the TB entrance on my stock intake a while back.

http://www.mustang6g.com/forums/showpost.php?p=1621771&postcount=111

 

[BMR Tech]

I acquired a spare intake to try and open it up. I didn't have much luck with it.

I had planned to try and open it up and port it and open and possibly re-shape the entrances.

But, I gave up. Trying to get the lower plenum to separate is a royal PITA.

 

[Bill88stang]

Thank you

Sponsored