The Chairman
Well-Known Member
No need to remove the front seat. Just the rear side panel.Do you have to REMOVE the FRONT SEAT & the SIDE PANEL to mount the seatbelt Anker? Where do you mount the seatbelt Anker?
Sponsored
No need to remove the front seat. Just the rear side panel.Do you have to REMOVE the FRONT SEAT & the SIDE PANEL to mount the seatbelt Anker? Where do you mount the seatbelt Anker?
No need to remove the front seat. Just the rear side panel.
It mounts along with the stock seatbelt:I have a CFTP GT500: Where & How do you install the front Driver Side Seatbelt Anker?
"THANK YOU VERY MUCH FOR THE PITCHER"It mounts along with the stock seatbelt:
I see you did the panel trim like I did. There are some minor differences in the factory anchor mounting from what is shown in the directions. I fought with it and ended up trimming the panel like that. Dremel comes in handy.It mounts along with the stock seatbelt:
Ya, I cut it like I had done on my GT350. As you can see, I didn’t need to slot it as much as I did... Kinda overachieved.I see you did the panel trim like I did. There are some minor differences in the factory anchor mounting from what is shown in the directions. I fought with it and ended up trimming the panel like that. Dremel comes in handy.
Lookin’ good! Did you have to bend either of the brackets on your belt clips?I recently installed the latest version of the Schroth QuickFit Pro 4 point harness.
you replaced the rear set buckle with one from a '15-17 too I take it?I just installed a Quick Fit Pro on the driver’s seat in my Bullitt today too.
No, I ordered the 2018+ version.you replaced the rear set buckle with one from a '15-17 too I take it?
Roll up with a zip tie is what I do in all of my cars.I have another question. Is rolling up the excess belt material and using a zip tie the way to go, or is there another way to tidy things up.
it's about FRIGGIN' TIME! How many years does it take to source the correct belt tongue when you get multiple emails (probably weekly) asking for an updated product?No, I ordered the 2018+ version.