oneheadlite
Well-Known Member
...looks to me like a pony in the grille and
a FORD emblem on the windshield.....................
Sponsored
I'm thinking very seriously of buy the Cervini GT500 hood and either tweaking the hood decal to fit over/around it, or leaving it off. A while putting the stock hood away for safe keeping.Yup. Actually, it was less expensive to simply sand bag the O E deck panel and buy the Ford Performance replacement. Swapped panels at the same time as I replaced the taillights. One and done !
im waiting for someone to make a NACA hood, then I'll swap and redo the graphics to look right.I'm thinking very seriously of buy the Cervini GT500 hood and either tweaking the hood decal to fit over/around it, or leaving it off. A while putting the stock hood away for safe keeping.
My "Mach 1" was taken off and put on a carbon fiber decklid. The factory just glued it on.Also a 2018+ blank decklid was put on right? did it to save the Mach 1 decklid? the Mach 1 seems to go back to the nice 15+ decklid without side indentations, but I bet its too risky to debadge the mach 1 emblem off one?
I'm not a big fan of the Mach 1 hood decal but like the lower stripe on the side, too.I removed a decent amount of stuff on my car, but I do dig the lower body stripe so I left that on.
is the rear emblem all adhesive mounted? how was removing it. i need to pull mine off to clean up that horrible piano black panel.I removed a decent amount of stuff on my car, but I do dig the lower body stripe so I left that on.