Pbenz
Member
- Thread starter
- #1
My 2017 Mustang gt Roush phase 1
So I just installed a bigger TB, 82mm pulley, injectors, bap & and a tune, I was racing my friend with an roush rs3 and my 4 gear went out.. I think.. not really?
So before this the stock rev is 7k.. after my tune I’m Reving to 7400-7600rpm I noticed my shifts from 3rd to 4th going from 7600rpm is grinding and feeling a little shitty at some shifts but it got better. Then when I was racing tonight my 4 gear just went out kinda. I revved my 3rd gear out then went for the change and it was like I totally lost 4gear it was 1/4 of the way in but just free revved then I put it in neutral and back into 4th and it was fine... I go to rerun it and the 3rd to 4th shift is going in but horrible feels sloppy weak like it’s so soft and only going in half way but it works perfectly fine holds the gear and power until I shift next.
I also drive normally and it feels normal no more soft shitty shifts but when I get back on it going from 3rd to 4th it feels so weak and doesn’t go in all the way??? What happened is my 4th about to go or what? Also what’s the best way to go about this if I need a new trans? Rebuild kit, how much is labor?
Or go with a stage one cailmer mt-82? How much would be the install for that?? I’m looking for a cheap budget friend way to fix this thanks!
Also my car is a 17 with the roush from factory. I’m 18k miles in do you think if I reflash it back to stock I could take it in for warranty work? Can i leave my TB pulley and injectors in or what?
So I just installed a bigger TB, 82mm pulley, injectors, bap & and a tune, I was racing my friend with an roush rs3 and my 4 gear went out.. I think.. not really?
So before this the stock rev is 7k.. after my tune I’m Reving to 7400-7600rpm I noticed my shifts from 3rd to 4th going from 7600rpm is grinding and feeling a little shitty at some shifts but it got better. Then when I was racing tonight my 4 gear just went out kinda. I revved my 3rd gear out then went for the change and it was like I totally lost 4gear it was 1/4 of the way in but just free revved then I put it in neutral and back into 4th and it was fine... I go to rerun it and the 3rd to 4th shift is going in but horrible feels sloppy weak like it’s so soft and only going in half way but it works perfectly fine holds the gear and power until I shift next.
I also drive normally and it feels normal no more soft shitty shifts but when I get back on it going from 3rd to 4th it feels so weak and doesn’t go in all the way??? What happened is my 4th about to go or what? Also what’s the best way to go about this if I need a new trans? Rebuild kit, how much is labor?
Or go with a stage one cailmer mt-82? How much would be the install for that?? I’m looking for a cheap budget friend way to fix this thanks!
Also my car is a 17 with the roush from factory. I’m 18k miles in do you think if I reflash it back to stock I could take it in for warranty work? Can i leave my TB pulley and injectors in or what?
Sponsored