*Edited* Ordered Procharger Stage 2 P1X.

[Nelsond003]

if that’s actual boost on a stage 2 kit then belt slip might be the issue. Maybe just not tensioned right.

It's also a Voodoo and not a 5.0? don't know. Its tensioned pretty tight, lol

Sponsored

 

[SolarFlare]

It's also a Voodoo and not a 5.0? don't know. Its tensioned pretty tight, lol

hmm Im guessing the balancer is smaller on those stage 2 setups which are likely offset by the higher revving motor. I think it should be seeing more boost.

 

[lightrules]

i wish the procharger crank support didnt eliminate the front sway bar. if anyone knows a work-around...

 

[80FoxCoupe]

i wish the procharger crank support didnt eliminate the front sway bar. if anyone knows a work-around...

There isnt one.

 

[turnswrench]

There isnt one.

10" cowl hood, engine lift mounts, custom firewall, two piece driveshaft?

 

[LSchicago]

Been running it on a 4.25" pulley. Ran 10.52@138 on a 93* day with 3500 DA. Car was spinning the tires into second. I just installed a 4.00" pulley for a little more boost, and soon adding a drag pack with 317/50/17 tires to replace the 19" NT555RII drag radials. Hopefully it will hook and see 9's without breaking.

 

[schmeky]

LSChicago,

That's most impressive.

I have pulley envy since I am running a 4.63".

 

[wingnutt]

i wish the procharger crank support didnt eliminate the front sway bar. if anyone knows a work-around...

https://www.hellionpowersystems.com/

 

[LSchicago]

i wish the procharger crank support didnt eliminate the front sway bar. if anyone knows a work-around...

Really not needed until you get into a D1X or bigger at higher boost levels. No need at 900RW, becomes a good idea anything over that. That said, my front sway bar is going bye bye soon anyway.

Sponsored