Dyno Day

[BE6Pony]

I am going to get the car dyno'd on May 7th, I am finishing up the tune with Torrie from unleased my mods are in my signature, so we will see what she puts to the ground, I am going to a mustang dyno which the guy told me what it puts down will need to multiplied by 1.12. will update you when I have the numbers.

Sponsored

 

[Bay1Stang]

What are you hoping to see?

 

[six_shooter]

Sounds fun, take a video of it on the dyno.

 

[BE6Pony]

What are you hoping to see?

I don't know hope it surprises me. We will see.

Sounds fun, take a video of it on the dyno.

Will do.

 

[zackmd1]

I don't know hope it surprises me. We will see.




Will do.

Basically the same mods I have so this should be interesting! Judging from MPTs dyno of another V6, I would expect over 300 whp and maybe 290-300 wheel tq. Granted MPTs dyno could have just been reading high so we shall see!

 

[Clarkson]

That's almost a full bolt-on V6. I hope you get 300whp or more. If that could be achieved its gonna be my upgrade pattern

 

[DR_]

I don't buy into that 1.12 factor. My car stock was 266 whp on a Mustang dyno. Using that correction factor I would be 298 whp stock which we all know isn't correct.

 

[fordguys550]

Should be cool to see your gains! Seems the LT guys make about the same tq as the shorty guys, but make a little more top end power over the shorties. I just payed for a set of tb ported intakes and and 72.5mm ported tb...there was a guy on the fb group that gained like 20hp with ported intakes...aparently guys are getting real good numbers with the tb ported intakes.

 

[BE6Pony]

Should be cool to see your gains! Seems the LT guys make about the same tq as the shorty guys, but make a little more top end power over the shorties. I just payed for a set of tb ported intakes and and 72.5mm ported tb...there was a guy on the fb group that gained like 20hp with ported intakes...aparently guys are getting real good numbers with the tb ported intakes.

That is funny because it was the next mod I had in mind. 20 hp for 300.00 Ill take it.

 

[larry1990]

I dyno'd I have the same setup minus the lt I have shortie headers and I got 257 whp and 264 tq but stupid me set my rev limiter to 6400rpm so my car wasn't able to rev out to 7000

 

[larry1990]

On Saturday I ported my upper and lower manifold apparently that should help help the air flow. Sometime in may I'm going back to dyno and dyno tune with tuner local to me

 

[BE6Pony]

I don't buy into that 1.12 factor. My car stock was 266 whp on a Mustang dyno. Using that correction factor I would be 298 whp stock which we all know isn't correct.

It is dude read up on mustang dynos they read 15% lower than dyno jets

 

[larry1990]

I have 257 rwhp and I calculated it to be 302 to thr crank I've only gained 2 hp from factory??!?!?!?!?

 

[larry1990]

And I have torries tune?!?!?!? What is going on?

 

[Clarkson]

I have 257 rwhp and I calculated it to be 302 to thr crank I've only gained 2 hp from factory??!?!?!?!?

The loss through transmission is just an estimate value so its not accurate at all.

Sponsored