D1X Powered

[Airborne]

How much are you guys making on a maxed out stage 2 D1X? (3.9 pulley spinning close to 65k RPM)

My goal is to crack 4 digits with consistent 4 second 60-130's, 9 second 1/4 mile times at 150 mph traps.

Mods: Built Gen1 short block (K1 H Beam rods, Wiseco pistons, gapped for boost, thicker wrist pins, calico bearings, king main bearings, block support kit, pac springs, arp head studs, main studs, mlx head gaskets)

Division X fuel system with fore FC2 controller, DW95# injectors, 485lph fuel pumps, division X rails, Lund Tuned on e85

Free flowing Texas Speed Long tubes and Borla S Types.

I have all the supporting mods (crank support kit, full suspension, etc etc)

Sponsored

 

[Jackson1320]

If you can spin that thing to 65k I would like to see it. If you are spinning to 6500 you need to spin higher. Why do you have all this stuff and only hit 6500? Other than that you should be at your goal

 

[Airborne]

If you can spin that thing to 65k I would like to see it. If you are spinning to 6500 you need to spin higher. Why do you have all this stuff and only hit 6500? Other than that you should be at your goal

By 65k I meant the blower RPM. I’m spinning the motor to 8k, sry about the confusion

on a d1x max blower rpm is 62,000 RPM

 

[Jackson1320]

By 65k I meant the blower RPM. I’m spinning the motor to 8k, sry about the confusion

on a d1x max blower rpm is 62,000 RPM

Ok that makes more sense. You should be at your goal

 

[SolarFlare]

I think @80FoxCoupe made close to 1100. But I don’t know what pulley that was

 

[80FoxCoupe]

I think @80FoxCoupe made close to 1100. But I don’t know what pulley that was

8in crank, 4.25 blower. Went 8.43 at 159 on the 4.0 pulley.

Sponsored