Center Console Material

[JetGray_Mach1]

I did Trufiber Replacement Front Dash (Dual Gauge), Replacement A-Pillars, I had a Flat Top-Flat Bottom Alcantara and CF Steering wheel made, Trufiber Replacement Front Radio/Navigation bezel (Have Not Installed Yet), Cup Holder, Gear Shift Bezel, Replaced the Door Handle Bezel, Door Grab Handle, Door Window Switch Bezel, Seat Memory Switch Bezel, were all done with CF Skinning over OEM Parts, Door Speaker Rings, 3-M Tape CF or Hydro-Dipping?, lower Dash Switch Knob switch CF Covers. The Only Other One I am planning to do is the Overhead MAP Light Assembly but waiting on a replacement panel, Maybe TruFiber Center Console SIDES and that's it. still thinking on those. Exterior: Anderson Composite CF Super Snake Double Sides CF Hood, GT-350 CF Side Rocker Panels, AR CF Quad Tip Rear Diffuser, CF Front GT350 Fenders, Shelby GT350R Type OE Rear CF Spoiler, Third Brake Light 3M CF Cover. I did most of this last winter. Good Luck

wow!!! any chance we can see pics?

Sponsored

 

[murick]

Just revisiting the center console material. From my order, is shows the following: "CNSL TOP PLT-LTHR/STITCHED INS". So, the console top plate is described as "LTHR/STITCHED INS". Doesn't that suggest that it's actually leather? Or no?

I believe it is PLT-LTHR which (I would guess) stands for polyurethane leather (or something like that), i.e. a synthetic leather, also known as faux leather.
STITCHED INS means probably stitched insert.

I do not believe there is anything from a real leather in my cabin.

 

[bassbaritoneca]

I decided to purchase the carbon fiber console and knee pads in the matte finish from Forgitec. They have a 20% off special going on right now so, I took advantage before the prices go even higher. ~$800 total out the door about the same amount as purchasing the stitched console from Ford. I hope this looks as good as the photos and youtube videos. The plastic console has been an eyesore for me for the past two years. I definitely didn't want the shiny surface. Will post pics once I have the pieces installed. If it looks great, I will pick up the dash pieces but, not the entertainment section or other pieces as I believe a little goes a long way. Then I will pick up the Shelby Gauge Pod to complete the interior.

My console, knee pads and dash now completely installed with the matte finish. I really like the subdued effect of the matte finish. Just waiting for my next service to get my Shelby Gauge Pod to complete the interior. A little Carbon Fiber goes along way! I am very pleased with the products from Forgitec.

 

[2021 Mach 1]

I believe it is PLT-LTHR which (I would guess) stands for polyurethane leather (or something like that), i.e. a synthetic leather, also known as faux leather.
STITCHED INS means probably stitched insert.

I do not believe there is anything from a real leather in my cabin.

I don't know. The order form shows it below. I thought the "PLT" was for "Plate" just as "CNSL" is for "Console" but maybe you are right. I'm not sure.

Sponsored