Carbon Fiber Addicts Anonymous Thread

[TBLGT350]

Hopefully it great looking stuff. My only concerns are the warranty against yellowing is only 6 months and the price has gone up $50 since you posted this.
It says they will send you $200 if you send them your stock pieces.

for the $200 I’m keeping my stock pieces

Sponsored

 

[Scott]

Where’s this from?

Dyna Performance.

 

[16Fastback]

Removed the OEM E-Brake handle and replaced it with a carbon fiber handle.

Looks great did that same thing a couple years ago mines real carbon fiber but slips over the original handle.a lot easier to install and works great.

 

[16Fastback]

 

[Jjmoberg]

Double sided tape or a pressure fit?

 

[16Fastback]

Double sided tape or a pressure fit?

Pressure fit but it needed a little material around the handle to fit tight.

 

[SheepDog]

For those of you that have the Forgitec overlays, has anyone tried adhering them with epoxy instead of using the tape for a better fitment?

 

[TBLGT350]

For those of you that have the Forgitec overlays, has anyone tried adhering them with epoxy instead of using the tape for a better fitment?

Good question

 

[Jjmoberg]

For those of you that have the Forgitec overlays, has anyone tried adhering them with epoxy instead of using the tape for a better fitment?

I had a piece that didnt fit and they told me not to use epoxy. But i think that was mostly CYA. That said the second set fit fine.

 

[Jjmoberg]

Pressure fit but it needed a little material around the handle to fit tight.

Well that one says 2015-2019. Oops. Is there actually a difference? One person asked if it fit a 2020 and the seller said no.

 

[2021 Mach 1]

For those of you that have the Forgitec overlays, has anyone tried adhering them with epoxy instead of using the tape for a better fitment?

I just used the tape and it's very tight. I warmed up the dash with a hairdryer first.

 

[TBLGT350]

I just used the tape and it's very tight. I warmed up the dash with a hairdryer first.

Nice. I ended up returning mine because I wasn’t happy with fitment and went a different route

 

[MarkM]

For those of you that have the Forgitec overlays, has anyone tried adhering them with epoxy instead of using the tape for a better fitment?

some very small dabs of silicone sealant on mine, very tight fit, really not much needed to hold them on

 

[ing3nious]

I have the radio, shifter, and door window trim pieces. I took my time with alcohol, hairdryer, the included tape and a tiny dab of clear silicone adhesive for corners. Fitment is pretty good but I can’t speak to the full dash.

 

[SheepDog]

Nice. I ended up returning mine because I wasn’t happy with fitment and went a different route

What did you use instead?

Sponsored