ghostang
Well-Known Member
I got the DTC error code to go away by changing the fourth value (not the third value) of IPC line 720-01-01.Did you ever get this DTC error code to go away? If so, what'd you change?
The IPC As-built spreadsheet instructions states to change the third and tenth values (*) of the of IPC line 720-01-01 as follows:
ORIGINAL - Auto High Beams 720-01-01 XX*X XXXX X*XX B & 0 = Disabled, F & 2 = Enabled.
The instructions should state to change the fourth and tenth values (*) of the of IPC line 720-01-01 as follows:
CHANGE - Auto High Beams 720-01-01 XXX* XXXX X*XX B & 0 = Disabled, F & 2 = Enabled.
Sponsored
Last edited: