Search results

Does anyone know if Eibach will sell the hardware for this kit? I currently own the setup its a few years old and both front/rear bars are in perfect conditions but i'd like to replace the hardware and bushings. (I.E - bushings, brake line bracket and etc)

Suspension: Lowering Springs, No spacers Wheels: Front - 19x10 (offset +40 mm) and Rear- 19x11 (offset +50 mm ) Tires: Front: Michelin Pilot Sport 4S (Front - 285/35r19 or should i go 275/35r19) and (Rear - 295/35r19) I already purchased the wheels but i am nervous about what tire size i...

I am looking to purchase SVE 350 wheels in a staggered setup. The specs are below. I am also lowered on springs with a 1-inch drop. I was wondering if anyone could confirm that this setup would work. I am not familiar with wheel and tire setups. I am coming from the same wheels but in 20in...

I am switching over from 275/35/R20 Michelin Pilot Sport 4S (square setup) to a staggered setup with 19s. I heard a lot of people prefer a 35 over a 30 and I wanted to know why? NOTE: Since i am switching to a 19s and MPS4S don't come in 35s i wanted to know if it was worth dropping to a 30

I have been looking to purchase the GT500 Hood style from Cervini's website. I was wondering if anyone has purchased a pre-painted hood from there and if so what are you thoughts on the paint job vs getting an un-painted hood and getting it painted...

I am looking to purchase a set of winter tires but am stuck between Bridgestone Blizzak LM005 or Blizzak WS90. Anyone out there have any experience with either? i would love to hear about it.

Hey guys looking to purchase the RTR Tech-5 Rear Wheel Gloss Black 19”x10.5” ( Offset: +45mm (ET45) / Backspacing: 7.52" / Weight: 24 lbs. ). Two questions tire size recommendations (Square setup) and if anyone is running these wheels if you could post a photo.

Hey Guys I am looking for some advice. I found that the IMRC Rod has failed and now the flaps in the manifold are stuck halfway closed/open. I am looking to replace the manifold. The biggest thing i am trying to avoid is a tune which I've seen most replacements require one. I've been told that a...

I recently discovered that my IMRC shaft has snapped, and I am looking to replace the manifold. I have found that 2018 manifolds are more ready-available. Could anyone tell if any modifications would be needed to swap manifolds?

Hello Guys, I have a 2016 ford mustang gt with a Ford Performance OIl Separator installed and i recently installed a Roush CAI and i noticed that on the left side of the CAI intake tube the vacuum nipple is straight were on the OEM intake tube the nipple is a 90 degree inlet. So when i attempt...

I've noticed that there is a gap between the bushing and the sway bar's lip to keep it center i believe. Any ideas how this could have occurred ?

Does anyone know how to replace these two bolts and where to find the replacement ?

https://ibb.co/D84fP9J I am looking to replace the back two bolts i believe they are 10M X 1.50 i accidentally stripped the bolts. I am trying to figure out how i replace it and where i would find the replacement bolt.

I recently been having issues with my A/C. It started with the A/C only blowing warm air out of all the vents after the car was warmed up. In the mornings i would be able to run the a/c for a little bit (but then i would turn it off and just drive with the windows down). A few days later i...

Thinking i might need to replace my A/C Compressor. Before i purchased the Compressor it self, i was wondering what other parts i might need or should replace while i am doing this work?

Does anyone know where i can get or download a service manual for a 2016 ford mustang gt manual. I attempted to get a PDF one and paid for it but it was a fake i just need a good source.

Hello, I my knowledge on suspension and overall cars is limited so i am wondering any recommendations for suspension upgrades for a lowered mustang on Eibach Pro-Lowering Kit w/ Eibach's Front and Rear sway bars. The wheels are 20X10 275/35/20 MPS4S. Any suspension upgrades that would make this...

I am new to the forum and was wondering if anyone had a link to the rules of the market place for selling an item.

Hello, I am looking for some recommendations on a clutch and fly wheel replacement for a daily driver that is looking to get performance out of a replacement but not to be tracked

I own a 2016 GT manual and i have noticed that in the last few weeks a noticeable grinding or whining sound is coming somewhere in the front end when i am in gear and accelerating. It doesn't do it when i have the clutch disengaged and rev. It only does it when i am accelerating in 1st,2nd and...