Looks long tube headers bolts

[24 GT]

So I recently got a pair of kooks lung tube headers but I unfortunately don’t have the bolts that are used to mount them to the engine and I was wondering if the OEM ones that are used on the OEM headers are capable of mounting the kooks headers or what I need to order their specific kooks bolts if someone could help me with this, I would appreciate thanks

Sponsored

 

[Cashley]

using stock hardware is preferred. you may or may not need to cust the studs down.

 

[24 GT]

Using the stock hardware so the oem or the kooks?

 

[robvas]

Using the stock hardware so the oem or the kooks?

Stock as in OEM

 

[24 GT]

Stock as in OEM

No yeah thanks it’s because I’m gonna get them installed by a shop soon but I was wondering if the oem header bolts worked or if I was going to have to go out and buy the kooks ones

 

[vinny89gt]

It is 100% impossible to get Kooks headers on using all the stock studs and nuts. You will need at least some bolts.

If you didn't get them with your headers, I'd call whoever you bought the headers from and explain. They'll probably ship them at no charge.

 

[24 GT]

So I would have to use a mix of them?

 

[vinny89gt]

So I would have to use a mix of them?

Yes

 

[Journey GT 435]

I don't have Kook's headers, but I did use all the studs and nuts from the stock set up. I have Stainless works headers, and they bolt on no problem. Never had to remove any studs. I did remove the low-pressure AC line to get access to one stud. Recharged the AC system after the headers were installed.

 

[24 GT]

OK, thanks I appreciate it. I’m just asking because I mean I’m getting a lot of mixed answers that. Yes I should have them and then know I can make OEM ones work

 

[2015 Silver GT]

Looks or Kooks? Your thread title is a bit confusing.

 

[Journey GT 435]

I have all the bolts that Stainless Power sent me with the headers, I didn't use them because I was able to use all the stock studs and nuts. I never even had to remove any studs to do the installation.

 

[Whitedevil95]

On my LTH Headers i used 100% all my stock studs. Worked Great, I removed a couple to make it easier to get them on, but but then I reinstalled the stud and then the nut.

Sponsored