Remove Torx from gurnee flap with stripped head

[WD Pro]

I don't know how thick the gurney is but if all else fails, drill the head off with a large diameter drill bit - stop as soon as the head breaks loose (no damage to anything), then remove the gurney completely and get some grips on the remaining bit of stud

And if that fails ...

WD

Disclaimer : I'm joking on that last bit ...

Sponsored

 

[Rapid Red]

I don't know how thick the gurney is but if all else fails, drill the head off with a large diameter drill bit - stop as soon as the head breaks loose (no damage to anything), then remove the gurney completely and get some grips on the remaining bit of stud

And if that fails ...

WD

Disclaimer : I'm joking on that last bit ...

And large amounts of masking tape.

 

[Mach 307]

Used the left handed drill bits and she is out!

 

[Linkster1666]

Plasma Torch? JHFC

 

[Johnny Rockit]

Drill the head off like a rivet. Use vise grip to remove the protruding threaded piece.

 

[NightmareMoon]

Plasma Torch? JHFC

Sponsored