What did you do to your S550 Mustang today?!

[Velgen]

Swapped out all the chrome emblems to Matte Black emblems thanks to [MENTION=13019]UPRSteve[/MENTION]

Sponsored

 

[stresstest]

Dash Cam

Add a fuse

I used it on my G sedan before this and was happy with it. I hardwired it to fuse 36 in the passenger footwell box.

Have any video I can see? Youtube link maybe? I'm seriously in the market for a solid cam for mine. I'd sure like to see some footage from this one going down the road.


Also what Coaster said above too ;)

 

[mikeyjobu]

UPR Billet Vertical Links. Took less than an hour, with hand tools on jack stands, and finally got rid of my wheel hop.

Looks great . I reading the product page on these: 2024 is loads stronger than 6061T6 - what treatment is your 2024, and are they clear coated at all? I addition to being stronger 2024T3 corrodes a lot more - in aircraft use, there's always a zinc chromate or epoxy finish used.

 

[FFPM46]

Steeda Ultralites, Steeda Camber Plates & Eibach 25mm all around

Just had these bad boys installed! Thanks STEEDA, drives as great as it looks! Also thank you David for the tour and advice on next mods. Excuse the dirty car :headbonk:

 

[stresstest]

Looks great . I reading the product page on these: 2024 is loads stronger than 6061T6 - what treatment is your 2024, and are they clear coated at all? I addition to being stronger 2024T3 corrodes a lot more - in aircraft use, there's always a zinc chromate or epoxy finish used.

These are good points. I'd also like to know before ordering if the inserts can be easily removed so I can powder coat them if they are not coated.

 

[Fatty]

Just had these bad boys installed! Thanks STEEDA, drives as great as it looks! Also thank you David for the tour and advice on next mods. Excuse the dirty car :headbonk:

Looks great! Can you post some pics closer to the front and rear wheel wells. Top view looking down if possible. Do rears stick out much? Thanks

 

[Velgen]

Just had these bad boys installed! Thanks STEEDA, drives as great as it looks! Also thank you David for the tour and advice on next mods. Excuse the dirty car :headbonk:

Car looks awesome Can't wait to see the other mods you'll be putting on

 

[FFPM46]

Looks great! Can you post some pics closer to the front and rear wheel wells. Top view looking down if possible. Do rears stick out much? Thanks

Will do tomorrow!

 

[David@Steeda]

[MENTION=23508]FFPM46[/MENTION] nice meeting you! One of the best stances I've seen yet! #thosespacers

 

[scoggy_doogan]

Can you post a pic of it in the car. Looking at it online it's hard to get a sense of how big the camera is.

No Problem.

 

[Coaster]

No Problem.

Thanks I figured it was smaller than it looked on Amazon.

 

[yessirrom]

No time to clean bugs. Must mod. Stanginator!

 

[chrisgonzales]

Installed this guy, Steeda CAI
[MENTION=10893]David@Steeda[/MENTION] thanks steeda for top notch car stuff

 

[plc268]

Well, my gt350 valence and exhaust showed up. Can't wait to put it on this weekend.

 

[SoCalTim]

Installed a FRPP deck lid panel :cheers:





​

Sponsored