What did you do to your S550 Mustang today?!

[GT Nate]

What I did to fix it was enlarge the hole on the bracket with the step drill bit they included. Then put a little paint on it to protect it from corrosion, and fit like a champ.

Realigning the hood would've messed up my stripes, and to my eye, my hood looks aligned just fine.

Drilling the bracket with the included bit was my thought as well. My hood lines up good with even gaps, didn't want to mess that up.

Sponsored

 

[PJR202]

Ran it into the menu at Sonic. I was pulling in and started sneezing hard. I slammed on the brake but it was too late. I wasn't quite straight and hit the pole. The headlamp can be buffed. The bumper can be fixed, but the fender is aluminum. I am a bodyman. I don't think I can fix the fender. I can't stud pull it. So I guess we will be blending the door too.

That is one of the most misfortunately comical things one could come up with. I admit I laughed, but inside I feel bad for you.

 

[Fatty]

Bigwormgraphix, gloss black, gloss red pin, 6.5 hours. Not perfect but darn good for a first timer.

 

[Fatty]

2

 

[GT Pony]

^^^ Looks good!

 

[MyFirst5.0]

much needed drop, wheels ordered coming in a week.

 

[plc268]

Drilling the bracket with the included bit was my thought as well. My hood lines up good with even gaps, didn't want to mess that up.

Yea, it's the best way, IMO. Redline will claim up and down all day that it's an alignment issue with your hood, but just adjusting their tolerances would fix the issue.

I'm the same way, my hood has no obvious uneven gaps. If it is, it's only off slightly. I wasn't going to mess with it.

 

[shelbywannabe]

Oil change and Steeda clutch spring

 

[ghig302]

WOW

Got 1st Virginia state inspection.we have to get it yearly here for safety checks..cost 16.00...took less than 30 minutes car had 13K ..2015 bought last April. Lots of mods..more to follow :ford:

If I bought a new year Mustang, I would want it to look just like this one!

Dave

 

[Mullethunter324]

Pony was getting dirty so I hit it with some CG products and have her looking good again.

 

[P51Guy]

Got the car ready for the Cops & Rodders car show at DeVry tomorrow. Should be a great day,mid to upper 60s with a lot of sun and about 300 cars.

 

[Voo Doo]

Bigwormgraphix, gloss black, gloss red pin, 6.5 hours. Not perfect but darn good for a first timer.

Looks good Fatty!! Congrats on doing it yourself!!

 

[Buzzard Bait]

Bigwormgraphix, gloss black, gloss red pin, 6.5 hours. Not perfect but darn good for a first timer.

That looks great! I didn't go all the way down the front and back with my stripes, but looking at yours I wish I had. May have to fix that.

 

[DoingOK]

New splitter, grill and brake duct cooling. I'm tired.

 

[Farmundeh]

Finally lowered. Eibach Sportlines went on earlier today:

Sponsored