Rotor profile and coating type.Just out of curiosity... What was the difference between gen 1 and gen 2 [MENTION=13288]Whipple SC[/MENTION]
Sponsored
Rotor profile and coating type.Just out of curiosity... What was the difference between gen 1 and gen 2 [MENTION=13288]Whipple SC[/MENTION]
Been a couple months. You get the motor done yet? Curious what it makes.My highest hp was 930rwhp/780tq STD on Gen2 whipple. Now Im sleeving motor going Gen3 and stage 2 blower cams. Can't wait to see what it'll make.
Just got my motor back yesterday. Going on vacation for 2 weeks then start putting everything together. Should be another month or so will have some resultsBeen a couple months. You get the motor done yet? Curious what it makes.
Sweet man. Keep us posted.Just got my motor back yesterday. Going on vacation for 2 weeks then start putting everything together. Should be another month or so will have some results
Will do ill post updates on my build threadSweet man. Keep us posted.
Well this is the Gen 3 dyno thread ... not sure if you're sarcastic or if we haven't had our morning coffee yetSo you picked up 290+ hp from exhaust and custom tune, or is there a Whipple on it too? Pulley size, Gen2, 3, fuel? All would be helpful.
Well this is the Gen 3 dyno thread ... not sure if you're sarcastic or if we haven't had our morning coffee yet
But to be super clear then, it is the Whipple Gen3 Stage 1 kit with the 6-rib, it's on pump 93 courtesy of Indiana.
You're correct on the 3.75 - I expected somewhere in the 600-ish neighborhood so I think the custom tune helped a lot.Slightly sarcastic. Great numbers for a stage 1, I assume 3.75 pulley. But if it were a balls out 3.25" pulley on ms109, I would have been disappointed. :cheers:
what pulley?This is brand new, haven't even picked the car up yet (will this afternoon!!!) but this is what the boys at the shop sent me yesterday. I'm very excited, this is more than I expected for sure - +290hp gain over stock!!
Other mods are just the AB and H-pipe and then I went with a custom dyno tune.
Thanks - updated the OP - it's the 3.75.what pulley?
Nice numbers I hope mine comes in there too.Thanks - updated the OP - it's the 3.75.