Meat coyote racing
Well-Known Member
- Thread starter
- #1
Finally installed the whipple kit and had it tuned this past Saturday! The car made 733 wheel and 566 torque at 12psi. National Speed in Wilmington, NC did the calibration. Oddly enough, the speed shop would not email me the data log of a WOT. The tech claimed it was technically "intellectual property" (bummed me out); I'll have to buy a NGauge to do my own I guess.
I am very happy considering the following setup:
Whipple Gen 2.5 (gen 2 body, gen 3 rotors)
Stage 2 kit
93 octane (no boostane)
3.625 Pulley
1 7/8 stainless works headers (w/ cats)
Relatively stock exhaust
I am very happy considering the following setup:
Whipple Gen 2.5 (gen 2 body, gen 3 rotors)
Stage 2 kit
93 octane (no boostane)
3.625 Pulley
1 7/8 stainless works headers (w/ cats)
Relatively stock exhaust
Sponsored
Last edited: