Which GT is faster?

[Jmtoast]

Show me something that says "Drag Mode Enabled", show me your drag mode being engaged.

I'm asking because I don't think your car has it. I remember reading back when the 18s came out, that you had to have the magneride to get the drag mode.

The guy above showed you. Mine is in the shop getting a supercharger and xpipe. I have it and use it every single time I drive it and get the notifications as I toggle thru them

Sponsored

 

[Bikeman315]

Do you have Magneride? I do see you have the 401A package.

Nope, Cali Special. 401A, no PP.

 

[Bluelightning]

You don't have to have magneride to have drag mode.

 

[NoVaGT]

I have the same switch to activate drive modes (including drag mode) and I do not have Magneride. Like I said before, the only requirement to get drive modes is 301A, 400A, and 401A trim.

source: I have a 2019 400A w/o Magneride and I have used drag strip mode.

I'm really confused now.

Bikeman315 has the 401A package, which shows Drage Mode engaged with a little light tree displayed in the dash. How does it work without the 401A package? Is there something else that displays the light tree?

ETA;

I think what I read, was that to do the sub 4 second 0-60, you had to have drag mode and Magneride. NOT that to get Drag Mode you had to have Magneride.

 

[Voluntearz_GT]

I'm really confused now.

Bikeman315 has the 401A package, which shows Drage Mode engaged with a little light tree displayed in the dash. How does it work without the 401A package? Is there something else that displays the light tree?

I get the same tree in the middle screen between the gauges.

 

[Jmtoast]

I'm really confused now.

Bikeman315 has the 401A package, which shows Drage Mode engaged with a little light tree displayed in the dash. How does it work without the 401A package? Is there something else that displays the light tree?

ETA;

I think what I read, was that to do the sub 4 second 0-60, you had to have drag mode and Magneride. NOT that to get Drag Mode you had to have Magneride.

I don't have 401A nor a digital tach. I have the Roush tach (digital but not like the 401a). You just get a little notification window that pops up and goes away once the selection is made.

 

[Bluelightning]

I'm really confused now.

Bikeman315 has the 401A package, which shows Drage Mode engaged with a little light tree displayed in the dash. How does it work without the 401A package? Is there something else that displays the light tree?

ETA;

I think what I read, was that to do the sub 4 second 0-60, you had to have drag mode and Magneride. NOT that to get Drag Mode you had to have Magneride.

I don't have the 401a in my car and it shows in the center display.

 

[DuRsT]

I'm really confused now.

Bikeman315 has the 401A package, which shows Drage Mode engaged with a little light tree displayed in the dash. How does it work without the 401A package? Is there something else that displays the light tree?

ETA;

I think what I read, was that to do the sub 4 second 0-60, you had to have drag mode and Magneride. NOT that to get Drag Mode you had to have Magneride.

For me it is displayed in the center section between the normal PP gauges when I change drive modes on my 400a M6 PP1.

Magneride not required. I'll grab a pic later.

 

[NoVaGT]

For me it is displayed in the center section between the normal PP gauges when I change drive modes on my 400a M6 PP1.

Magneride not required. I'll grab a pic later.

No need, I believe you. I was miss-remembering what I read over a year ago when the 18s came out. It's all good.

 

[Eritas]

AdvanceTrack are electronic nannies you disable by pulling apart harness plug under the hood. Takes....5 seconds.

Actually it takes 7 seconds, holding the traction control button until a warning "AdvanceTrac Off" appears.

Unplugging that connector takes much longer, getting out of your car, opening the hood, propping the hood, unplugging the connector, dropping the hood, and getting back in the car.

 

[DuRsT]

No need, I believe you. I was miss-remembering what I read over a year ago when the 18s came out. It's all good.

All good man. Once I got over 40 that happens a lot more.

 

[Jmtoast]

No need, I believe you. I was miss-remembering what I read over a year ago when the 18s came out. It's all good.

All I know is it's awesome. Best thing about the car. Thast drag mode about breaks your neck when going from 1st to second. And if you have an upgraded exhaust the sport+ mode down shifts are just addictive.

 

[Jmtoast]

Actually it takes 7 seconds, holding the traction control button until a warning "AdvanceTrac Off" appears.

Unplugging that connector takes much longer, getting out of your car, opening the hood, propping the hood, unplugging the connector, dropping the hood, and getting back in the car.

Yeah that's all I do also.

 

[TheReaper]

My 301a has drag mode. The 301a non PP cars with 355 gears should be the quickest in the 1320.

 

[Diocletian]

Do you have Magneride? I do see you have the 401A package.

I have a PP1 wih 401a and no magneride and I have the drag mode. All Drag mode is is an option for the drive mode selector: Normal, Sport/Sport+, Track, Drag and MyMode(Custom).

Drag mode is considered the 'least restrictive' and more of a 'set it and forget it' option for the strip. This mode STILL DOES NOT fully disable AdvancTrac, which is different than TRACTION CONTROL. To fully disable AdvanceTrac, you press and hold the traction button for 5-7 seconds(while stopped) but keep it mind it will re-activate if you switch drive modes. Which is why some of the speed demons here will just pull the AdvanceTrac harness located easily under the hood.

Hope that clears everything up lol

Sponsored