SW LT Performance Connect Question?

[TonyN]

Do the "performance connects" on the stainless works/power headers come long enough to delete the bottle neck of a "factory connect" aftermarket catback (IE the gibson catback)?

Or do I need to weld in a small section to delete the bottle neck?

Basically, I plan to run longtubes with the perfomance connect (no bottle neck) but need to know if I will be able to cut the 3-4" reduced section off of my Gibson and properly connect the LT's?

Searched and didnt come up with anything. :frusty:

Thanks in advance guys!

Sponsored

 

[rainier446]

No. Check this thread below.

www.mustang6g.com/forums/showthread.php?t=16678&highlight=performance+connect

 

[TonyN]

Thanks you!

 

[svtfever]

I have a catless performance connection from arh FS. not sure how it compares to the sw one

 

[TonyN]

I have a catless performance connection from arh FS. not sure how it compares to the sw one

How much are you asking?

 

[RubyRedBoost]

How much are you asking?

All you need is 2 3" ID to OD pipes by whatever length is missing. On the Corsa is was roughly 6". You can source then really cheap or just have an exhaust shop cut some for you. It cost me like 15 bucks for pipes and clamps.

Sponsored