Rock Guards HP Only Please

[Whitedevil95]

Hello,
Welp it happened. I got my 2022 Mach with 4k miles I had the whole front end PPF'd and I now have a rock chip on the lower rear quarter, which I now see is a common issue, I sure wish I got that area PPF'd too. I am looking at the RockBlocks but i am open to whatever works best with the HP front wheel arch plastics. LMK what you have and if any of the options are a direct fit. Thanks guys!

Sponsored

 

[RobZ71LM7]

Rokblokz, just trim them around lower section of the HP lip for a better fit. I've used them in GT size and PP2 size (PP2 has same wheel size and offset as HP). I'm currently using GT size because I run enough negative camber on my 305's up front that they tuck in nicely. PP2 size looks too much like a truck or something you'd see on a WRX.

 

[Skye]

I have not installed the HP wheel lips.

I have installed a set of ZL1 Add-On flaps in the front. Post #25 has details and photos.

https://www.mustang6g.com/forums/threads/rock-guards-zl1-addons-vs-autofanatic.171611/

For the rear quarters, I continue to use the factory HP guards.

 

[IPOGT]

I have not installed the HP wheel lips.

I have installed a set of ZL1 Add-On flaps in the front. Post #25 has details and photos.

https://www.mustang6g.com/forums/threads/rock-guards-zl1-addons-vs-autofanatic.171611/

For the rear quarters, I continue to use the factory HP guards.

I did two mods to mine. The factory Mach 1 front and rear guards and moldings. I think it looks more complete even with the Standard wheels.

 

[TonyNJ]

That area in front of the rear wheel is one of the easiest places to DIY PPF. Order a 24"x54" roll on Amazon for $25 bucks and you'll be able to do both sides. A little touch up paint before you apply the film. You'll never see it.

Make yourself a pattern similar to this with construction paper and trace it out on the PPF. You'll never get a chip there again.

Extend the patter into your door jam if you can.

Sponsored