Rock50
Well-Known Member
- Thread starter
- #1
Got this idea from an older thread. There is this SmartTOP module available for convertibles that allows for one touch operation etc. Well, this thing also has the ability to remember the last drive mode on key cycle or always switch to Sport+ or MyMode. Why not install it on a fastback?
Company says the needed connector is not available on fastbacks, which is true of course, but looking at pictures, it connects to one of the motors (motor 2 on driver’s side). From the schematics, all that this basically provides is a way for the module to piggyback for power, switch input, some sensor inputs and access to the MS-CAN network. I am thinking this thing should work just fine with only power and a patch into the MS-CAN network wherever (one such location is near the OBD II connector). Anyone ever try this?
I hate switching modes every time, even if it is just a double tap to go to MyMode. Just not sure if it is $350 worth to get one for an experiment that may or may not work.
Company says the needed connector is not available on fastbacks, which is true of course, but looking at pictures, it connects to one of the motors (motor 2 on driver’s side). From the schematics, all that this basically provides is a way for the module to piggyback for power, switch input, some sensor inputs and access to the MS-CAN network. I am thinking this thing should work just fine with only power and a patch into the MS-CAN network wherever (one such location is near the OBD II connector). Anyone ever try this?
I hate switching modes every time, even if it is just a double tap to go to MyMode. Just not sure if it is $350 worth to get one for an experiment that may or may not work.
Sponsored
Last edited: