Sponsored

REAR VIEW MIRROR BLURRING PROBLEM

superman07

Well-Known Member
Joined
Jan 12, 2016
Threads
16
Messages
1,437
Reaction score
549
Location
columbus ohio
Vehicle(s)
2016 gt350
Mine does this horribly also. its non usable pretty much except for knowing if you have flashing lights behind you. Was going to report to the dealer. Very minor pressure from my finger and it clears right up. All speeds and rpm.

it is tight as snot to the window, the mirror itself is too loose in the overall housing.
Sponsored

 

theman1990

1 arm, 4 cars, 0 autos
Joined
Feb 10, 2016
Threads
12
Messages
127
Reaction score
87
Location
Tampa, FL
First Name
Daniel
Vehicle(s)
GT350 Tech, GT350R
That is most likely vibration from the flat plane crank . . . some of us have it and some of us don't. Sorry I couldn't be more help.
I disagree!! My tech 350's mirror is perfect but my R's mirror is useless. I isolated it down to wheels. At high speed push the clutch in and see if there is a change. If it persists, it's not the engine. Or shut it off completely (if you dare/can).
 

lemers

Globetrotter
Joined
Aug 30, 2015
Threads
30
Messages
3,620
Reaction score
1,112
Location
Carlisle, PA
First Name
Mike
Vehicle(s)
2016 GT350
Vehicle Showcase
1

Dave99GT

Active Member
Joined
Jun 6, 2014
Threads
0
Messages
29
Reaction score
2
Location
Milwaukee
Vehicle(s)
2014 Mustang Convertible
My 2003 Cobra had bad vibration in the mirror like you describe. Had to have the driveshaft replaced, that cleared it up. Was a common problem with 2003 Cobras.
 

Sponsored

GTP

Deutsche Pony
Joined
May 27, 2015
Threads
260
Messages
5,973
Reaction score
3,846
Location
Indy
Website
www.BambergAudio.com
First Name
Philip
Vehicle(s)
2019 GT PP1 A10 Outrageous Orange HPDE mods
This is one of the symptoms of the 50-70mph driveline vibration issue.

Even though the set screw is tight, the bracket still has play with the windshield. I have not studied this further, but I suspect that filling the small gap (such as with the rubber in the video on the first thread page) should work.

Edit: My mirror mount cable comes in next week, for my radar detector. At that time, I would look into the situation closer and report back.
 
Last edited:
OP
OP
SROLD

SROLD

Active Member
Joined
May 11, 2016
Threads
4
Messages
29
Reaction score
16
Location
PHOENIX,AZ
First Name
STEVE
Vehicle(s)
GT350
Thanks everyone for your serious comments..rubber and inside tightening look like great solutions to this problem. Will stop using all caps.
 

NipSC4328

Well-Known Member
Joined
Feb 19, 2016
Threads
5
Messages
318
Reaction score
134
Location
Northern Oklahoma
First Name
Jim
Vehicle(s)
2020 GT500 Twister Orange w\ Black OTTS
Thanks everyone for your serious comments..rubber and inside tightening look like great solutions to this problem. Will stop using all caps.
No problem, hope you get this resolved. BTW, all caps is considered shouting, hence the comments. Cheers!:thumbsup:
 

MTWINN

Well-Known Member
Joined
Apr 25, 2016
Threads
3
Messages
194
Reaction score
101
Location
Southern IL
First Name
Mike
Vehicle(s)
2017 Shelby GT350
I JUST DROVE MY NEW GT350 FROM WISCONSIN TO PHOENIX AND HAD AN OVERALL TREMENDOUS TRIP EXCEPT FOR ONE ANNOYING PROBLEM. THE REAR VIEW MIRROR HAS A SMALL VIBRATION AT SPEED EVEN ON RELATIVELY SMOOTH INTERSTATE HIGHWAYS. A QUICK GLANCE AT IT AND IT IS VERY DIFFICULT TO DETERMINE WHAT VEHICLE IS BEHIND IN THE MIRROR BECAUSE OF THE BLURRING. PUTTING MY HAND ON THE MIRROR DOES STOP IT BUT I SHOULD NOT HAVE TO DO THIS. SCREW HOLDING IT TO THE WINDSHIELD WAS TIGHTENED BUT DID NOT STOP IT. HAS ANYONE ELSE HAD THIS PROBLEM...IF SO...HOW SOLVED OR IS IT A WARRANTY PROBLEM?

OUTSIDE MIRRORS DO NOT VIBRATE AND BLUR.
Mine does not vibrate and blur image as you've described.
 

GT_Dave

Well-Known Member
Joined
Dec 13, 2015
Threads
11
Messages
1,075
Reaction score
690
Location
NE Illinois
Vehicle(s)
1970 Mach 1 408EFI , 2016 GT350
My rearview mirror has had no vibration at any speed, there has to be an identifiable cause and solution for those that have this problem
 

Sponsored

GTP

Deutsche Pony
Joined
May 27, 2015
Threads
260
Messages
5,973
Reaction score
3,846
Location
Indy
Website
www.BambergAudio.com
First Name
Philip
Vehicle(s)
2019 GT PP1 A10 Outrageous Orange HPDE mods
Today I removed the dash bezel that is around the headlight switch. I applied flocking tape at several points to solve the intermittent rattle, hopefully.

So I looked into the mirror situation. In spite of the set screw being tight, the shoe plate still has slack with the windshield. So I applied some of the flocking tape along the two edges of the plate. I bet that will fix it. I will report back Monday, as that is my next freeway run.
 

HizliBullet

GT350
Joined
Nov 16, 2015
Threads
76
Messages
2,491
Reaction score
874
Location
Canada
First Name
Mustang
Vehicle(s)
16 GT350, 17 Edge Sport
Vehicle Showcase
1
whatever behind is in the past (mine vibrates too)
 

lemers

Globetrotter
Joined
Aug 30, 2015
Threads
30
Messages
3,620
Reaction score
1,112
Location
Carlisle, PA
First Name
Mike
Vehicle(s)
2016 GT350
Vehicle Showcase
1
Just another reason not to worry about how big the R wing is
 

84venom

Well-Known Member
Joined
Jan 8, 2016
Threads
47
Messages
351
Reaction score
213
Location
NJ
Vehicle(s)
2000 Cobra R, 2016 GT350 TP DIB w/White Stripes
So I'm not the only one with a vibrating mirror!! Thanks for putting it out there....
 

Zombo

befejezett
Joined
Apr 1, 2016
Threads
20
Messages
1,033
Reaction score
737
Location
NJ
Vehicle(s)
2016 GT350 Track Pack - Race Red, Blk Roof - G5405
I never noticed a resonating rear view mirror, regardless of engine RPM, until recently, when I was driving on the highway (something I rarely do in the GT350). I have to concur with [MENTION=16078]GTP[/MENTION] that it's a drive line issue, not a voodoo issue. Driveshaft or something in the rear end, perhaps.
Sponsored

 
 








Top