ProChargerTECH
Well-Known Member
- Joined
- Oct 23, 2014
- Threads
- 105
- Messages
- 2,408
- Reaction score
- 1,297
- Location
- Boostville
- Vehicle(s)
- 2015 Mustang(s)
- Thread starter
- #1
1) All systems shipped later then 6/01/15 have current file.
2) The few customers that had the issue have all been emailed the new file.
Finished with our HO and STG2 updates.
Emails are starting to go out now.
I know of 2 members that already have emails in their inbox.
IF YOU NEED AN UPDATE:
You MUST submit the following to [email protected]
Serial #
What Kit (HO or STG2)
What Intercooler (HO or STG2) since we have people upgrading already.
Full Name
Screen name on forum (just so its easier to track)
Happy Boosting everyone!
2) The few customers that had the issue have all been emailed the new file.
Finished with our HO and STG2 updates.
Emails are starting to go out now.
I know of 2 members that already have emails in their inbox.
IF YOU NEED AN UPDATE:
You MUST submit the following to [email protected]
Serial #
What Kit (HO or STG2)
What Intercooler (HO or STG2) since we have people upgrading already.
Full Name
Screen name on forum (just so its easier to track)
Happy Boosting everyone!
The final ECU Calibration has been mapped and tested.
And results as good.Cures the issues, AND we added a little power
![]()
Here is a "worst case" dyno graph from todays heat soak test runs.
- Last run out of back to back to back runs
- 91 octane fuel from QuikTrip (no 93)
- Knock Sensors still turned on (could have easily made more without them, and made "pretty" smooth graphs like others)
- All systems still enabled, long term, short term, etc.
This will be the exact file sent out for customers.
(We actually tested these files, by emailing them to ourselves, just as customers would get them)
So there you go, over 600rwhp on a Mustang Brand Dyno.
After back to back to back runs, on 91 oct and LOW BOOST.![]()
![]()
Sponsored
Last edited:
