sanchezcruz_20
Well-Known Member
- Joined
- Apr 10, 2015
- Threads
- 16
- Messages
- 370
- Reaction score
- 98
- Location
- Columbus, OH
- Vehicle(s)
- 2015 Ford Mustang GT
- Thread starter
- #46
PCV System
Remove the passenger PCV line:

Remove the line going to this port behind the throttle body and install supplied cap:

Run supplied hose from valve cover vent around front of vehicle:

Install supplied line for driver's side valve cover vent:

Both lines will tie into the T on the air inlet:

Disconnect IMRC vacuum line at rear of engine bay near firewall:

It runs from the firewall to the front of the motor. Pull the line from the motor completely. Pictured here:

Splice a T into the driver's side valve cover vent line that was previously run:

Connect hose from T to the IMRC vacuum port at the rear of the engine:

Thanks bud.Love the play-by-play on the install. Very insightful.
Remove the passenger PCV line:

Remove the line going to this port behind the throttle body and install supplied cap:

Run supplied hose from valve cover vent around front of vehicle:

Install supplied line for driver's side valve cover vent:

Both lines will tie into the T on the air inlet:

Disconnect IMRC vacuum line at rear of engine bay near firewall:

It runs from the firewall to the front of the motor. Pull the line from the motor completely. Pictured here:

Splice a T into the driver's side valve cover vent line that was previously run:

Connect hose from T to the IMRC vacuum port at the rear of the engine:

Sponsored














Can't wait I see what she puts down and hopefully quiklybsave up for this kit soon !!!! Awesome job