OBX Headers

[michelevo]

I have an mbrp race, but it conects to the stock headers, so i will need to cut that part and then weld it to the mid pipes conections of the headers , i want a full 3 inches exhaust, i guess it wouldn't be to expensive in a shop to get that done

Sponsored

 

[Terminator2]

I have an mbrp race, but it conects to the stock headers, so i will need to cut that part and then weld it to the mid pipes conections of the headers , i want a full 3 inches exhaust, i guess it wouldn't be to expensive in a shop to get that done

Yes you got it and yeah it shouldn't cost much to weld in a little piece of 3" to join it.

 

[Jpjr21]

I'm sure they will bring the sound levels down about 5dB. My catback consists of X pipe suitcase resonator delete, mid mounted 18" case Dynomax race bullets, rear muffler deletes, 4.5" single wall non rolled stainless tips.
Exhaust Costs.
2 2.5" 18" long case Dynomax race bullets $90
1 2.5" stainless universal X pipe $30
2 4.5" stainless tips $45
OBX headers with bullet resonators and midpipes $600
Muffler deletes $100
Mid muffler and X pipe install $175.
Cost to have mid pipes welded to my catback $? Probably $50

Where did you get the tips?

 

[Terminator2]

I'm sure they will bring the sound levels down about 5dB. My catback consists of X pipe suitcase resonator delete, mid mounted 18" case Dynomax race bullets, rear muffler deletes, 4.5" single wall non rolled stainless tips.
Exhaust Costs.
2 2.5" 18" long case Dynomax race bullets $90
1 2.5" stainless universal X pipe $30
2 4.5" stainless tips $45
OBX headers with bullet resonators and midpipes $600
Muffler deletes $100
Mid muffler and X pipe install $175.
Cost to have mid pipes welded to my catback $? Probably $50

Where did you get the tips?

eBay
http://m.ebay.com/itm/Stainless-Ste...7-quot-Long-/141531710441?txnId=1288709922004
I had to cut the inlets down about an inch so they became over 2.5" ID and would fit my exhaust pipes.

 

[Jpjr21]

Cool thanks!

 

[Terminator2]

Cold start and a little revving in the rain. Car sitting over 24 hours. Last rev is to 7200. Car doesn't crackle or pop at all once warmed up (CHT only 115 at the end) I'll get better videos once it quits raining. If it ever stops lol.
[ame]
Camera is like 2 feet behind the car resting in my wife's cars grill lol.

 

[Chameleon]

Sounds awesome.

 

[Terminator2]

Sounds awesome.

Thanks it sounds a lot better once it's fully warmed up. I'll get a drive by video if it ever stops raining it has been for almost 3 straight days now.

 

[Terminator2]

Fully warmed up revving to 7300. My wife said her ears hurt (she was the one videoing lol).

 

[TheDivaDanielle]

Mutual high-5 to [MENTION=23439]Terminator2[/MENTION] and our different but awesome long tube headers

 

[Terminator2]

Mutual high-5 to [MENTION=23439]Terminator2[/MENTION] and our different but awesome long tube headers

They are most likely made at the same factory over seas.

 

[66sprint6]

Sounds great! Hows the volume inside the car? Any drone?

Matt

 

[Terminator2]

Sounds great! Hows the volume inside the car? Any drone?

Matt

Zero drone and it's pretty quiet inside the car until I go wide open throttle.

 

[highvoltage]

Sounds awesome!

 

[highvoltage]

Any particular vendor you went through on ebay? There are a few selling these.

Sponsored