No start issue after clutch install.

[CodyG]

2016 GT with roush blower and 727 upgrade.
Tossed in an RXT with flywheel.
I'm getting fuel, smell it in the exhaust, but it doesn't seem to be getting spark.

I am reading rpm, have good voltage, no CEL. I've tried the brake and clutch trick to start but it just cranks until the timer stops it.

Any ideas are appreciated.

Sponsored

 

[LxMike]

Crank Relearn.....

 

[CodyG]

Crank Relearn.....

Can't crank relearn without the car running.

 

[Grimreaper]

Hate to send you on an egg hunt but I'd double check any wiring and also the wiring that runs above the tunnel/bell housing for it getting pinched. Grounds too.

Rpms register on the tach or via scanner such as sct/ngauge? Should show few hundred while cranking.

 

[CodyG]

Hate to send you on an egg hunt but I'd double check any wiring and also the wiring that runs above the tunnel/bell housing for it getting pinched. Grounds too.

Rpms register on the tach or via scanner such as sct/ngauge? Should show few hundred while cranking.

Rpms register both on tach and on datalogger.

 

[Cobra Jet]

2016 GT with roush blower and 727 upgrade.
Tossed in an RXT with flywheel.
I'm getting fuel, smell it in the exhaust, but it doesn't seem to be getting spark.

I am reading rpm, have good voltage, no CEL. I've tried the brake and clutch trick to start but it just cranks until the timer stops it.

Any ideas are appreciated.

@CodyG

Check out this recent thread, wondering if this might be your issue too:
https://www.mustang6g.com/forums/threads/wiring-harness.146116/

Sponsored