Ngauge Knock PID issue

[bonomo53]

Recently my Knock PID on the ngauge will stop working after going WOT just gets pegged at 0. If i unplug and plug back in the ngauge it still wont work but if i turn the car off and back on it starts reading again. Just trying to figure out if its a Knock Sensor issue or a ngauge issue. I tried reaching out to LUND but they are unable to help without me paying $50. Had anyone seen this?

Sponsored

 

[strongholdsteve]

Lund..oh boy oh boy

 

[DavidHuff]

Customer Service.PLEASE!

 

[mustang1]

there might be new firmware for the ngauge

 

[bonomo53]

there might be new firmware for the ngauge

I made sure FW is up to date.. Ran a data log last night and in the log it even shows knock as all 0s

 

[codemanstang]

stupid question, but what setting/gauge in the guage is it that shows the knock? spark advance?

 

[3beeps]

stupid question, but what setting/gauge in the guage is it that shows the knock? spark advance?

No it's called KNOCKR (Knock Retard). When it's positive, it's pulling timing. When it's negative, it's adding timing.

 

[mustang1]

what is PID for knockr ? You could test this with a blue tooth obd and Torque app.

 

[codemanstang]

No it's called KNOCKR (Knock Retard). When it's positive, it's pulling timing. When it's negative, it's adding timing.

I have the 6 pack of gauges selected. tried to modify one and searched for kNOCKR, couldnt find it? :shrug:

 

[CORNFED]

Did you scan your car and select the right pid list? Go to gauges and do a re-scan and select 2011+ gasoline fords I believe its called. That should give you a full list of PIDS including KNOCKR

 

[codemanstang]

Yeah I think it says all ford vehicles 2008 and newer....should I be scanning with engine running? Or just ignition on?

Nm I just re did the scan and found knock. Sweet thanks man!

Now total.newb I want this to stay under 0? At idle it's just reading 0.00 and.not fluctuating at all

 

[CORNFED]

Exactly. Above zero or any positive digit is knock. Have you dataloged it yet? If so load the datalog onto datazap and share it here.

 

[codemanstang]

Exactly. Above zero or any positive digit is knock. Have you dataloged it yet? If so load the datalog onto datazap and share it here.

I'll try to get a lot uploaded tonight. I ran it today and numbers do change in accelerating. In fact I say positive 2.65 so I got to get the logs to lund

 

[bonomo53]

Thanks for everyones response seems like the thread got a little off topic but i'm having the ngauge replaced due to touchscreen issues and i'm hoping that will resolve this one as-well.

Sponsored