Koni is here!

[scott_0]

installed the rear Koni's and BMR performance springs this afternoon, much easier than some made it out to be, started at 230 and finished by 415 on jack stands in my driveway, did it by myself with the exception of having my lovely wife come out and push down on the rotor with her foot while I pulled the spring out, I'm sure having a cordless impact wrench helped speed it up for me. loving the rear ride height! I set the rear to a 1/2 turn from full soft, feels close to stock after a around the block ride. I'll install the fronts tomorrow morning

Sponsored

 

[ForTehNguyen]

what kind of BMR springs did you get, interested in the minimal drop SP089 fronts and performance SP082 rears with these shocks

 

[scott_0]

what kind of BMR springs did you get, interested in the minimal drop SP089 fronts and performance SP082 rears with these shocks

the performance sp080

 

[jayman33]

We finally have these

We'll be putting them to the test as best we can with a few cars around here

 

[GTBOB]

Someone sell me their rear, takoff PP shocks!!!!!

 

[SR56]

$668 shipped now, lowest price I've seen!

Did you order them? Just trying to gauge how long it took to get them. I've got an install on the 9th for suspension and need them to be here for it.

 

[SR56]

Someone sell me their rear, takoff PP shocks!!!!!

If you haven't found a set by June 10, let me know. I'll be getting my install by then.

 

[TunaFish15]

installed the rear Koni's and BMR performance springs this afternoon, much easier than some made it out to be, started at 230 and finished by 415 on jack stands in my driveway, did it by myself with the exception of having my lovely wife come out and push down on the rotor with her foot while I pulled the spring out, I'm sure having a cordless impact wrench helped speed it up for me. loving the rear ride height! I set the rear to a 1/2 turn from full soft, feels close to stock after a around the block ride. I'll install the fronts tomorrow morning

Can't wait to see a side profile shot of the whole mustang after the complete install.

 

[scott_0]

Can't wait to see a side profile shot of the whole mustang after the complete install.

here you go man, after a fresh wash, Im loving the Koni's and BMR springs!

 

[Todd15Fastback]

^^^That looks awesome!!

 

[SR56]

here you go man, after a fresh wash, Im loving the Koni's and BMR springs!

[MENTION=10893]David@Steeda[/MENTION],

How does this stance compare to the Steeda Linear Sport springs?

 

[Todd15Fastback]

@David@Steeda ,

How does this stance compare to the Steeda Linear Sport springs?

The Steeda sport springs sit up a tad bit higher than those. The ultralite linears sit like those BMR performance springs.

 

[MANDARK]

Going through the install now and can't get the two spline bolts on the fronts off. We've given them a good hammering and the aren't budging. Any one else run into this or have any other ideas to get them loose?

 

[Hinds90]

I just left the nuts barely on the bolts and used a good hammer like the Cj pony part install shows.

 

[scott_0]

Going through the install now and can't get the two spline bolts on the fronts off. We've given them a good hammering and the aren't budging. Any one else run into this or have any other ideas to get them loose?

I assume higher mileage cars are harder to get out, but mine popped out easily with a normal sized claw hammer after about 10 whacks, maybe try a 4lb sledge.......

Sponsored