Intake valley question

[50racer]

So I installed my Stage 4 Fore fuel system and Holley sniper intake this past weekend. So I got power to the pumps and noticed i had a leak by the FPR where i didn't tighten the connection enough. No big deal tightened and it was good. At least so i thought. I didn't see anything else leaking anywhere so i went to go take the car for the initial cruise log for my updated tune. It was no more than 2 miles total. Well the Miles till empty went from about 213 to 193 by the time i got home. So i was like either i messed up the sensor dropping the fuel hat back in tank or fuel is going somewhere. When i got home i left it running and saw under the intake (where i ran the fuel lines since lot of room under the holley) I left one of the y block connectors loose so it was coming out pretty good. Well the fuel was going to the intake valley and then i noticed the hole in the back of the block when it wasn't filling up. That is my question is where does that go. I just need to know if i need to drain and replace some oil or trans fluid if it heads down in those areas. Now there was a bunch of fuel on my garage floor so hoping that it just passes through somehow. Thanks for your input.



I sniped this image from MMR since it had a clear shot of the hole i am referring to. My apologies if it needs to be removed i understand.

Sponsored

 

[beefcake]

its a drain, there won't be an open hole in the engine that goes to your coolant or oil