Educate Me

[BurnsS550]

I went in for service yesterday to address a noise coming from the rear. It sounded like exactly what it was. Somehow the shock tower bolts had started to back themselves out.

My question is.. Is any of the related hardware "one-time use?"
From the write-up

"shock absorber fasteners are factory original fasteners which were removed and reinstalled when the lowering components were installed on the vehicle. The are one time use fasteners which are supposed to be replaced if removed for any reason."

Any feedback is appreciated.

Sponsored

 

[Monopoly]

Correct did you remote the bolts already? I'm debating the same issue (in process of installing FRPP track pack susp kit)

I also heard using Loctite on the bolts is just as good and torque back to spec. But recommended to replace suspension bolts/nuts after removing.