Drive shaft replacement

[Luckystang]

I have a new 2021 Mach 1 HP.
With the 10R80.
I am looking to replace the stock drive shaft with one piece Aluminum.
Does anyone know if DynoTech makes one for our Mach 1?
Thanks for the help.

Sponsored

 

[traxiii]

I have a new 2021 Mach 1 HP.
With the 10R80.
I am looking to replace the stock drive shaft with one piece Aluminum.
Does anyone know if DynoTech makes one for our Mach 1?
Thanks for the help.

No, but be sure and post pics when you get it.

 

[Luckystang]

I was able to contact Steve with DytoTech late yesterday.
It will be March before they can fill the order.
I will keep you posted.

 

[JOKER M1]

@Luckystang - good to know. I contacted QA1 last week and they expect to have one but no dates yet

 

[Luckystang]

I will keep you updated when I hear back from Steve from DynoTech.
Looks like I am going to go with the GForce half Shaft.
Steeda will be installing them along with IRS Subframe Support brace,
G-trac Brace and the Shaker Hood system by Classic Design.
I will be driving to Steeda in Valdosta GA on Jan. 23 for the install on the 24th.

 

[Luckystang]

I just order the QA1 Carbon driveshaft from Steeda. They will install on the 24th.

 

[Mach1soldier]

Isnt the Mach1 driveshaft same fitment as a GT?

I’m pretty set on getting the carbon fiber QA1

 

[JOKER M1]

Isnt the Mach1 driveshaft same fitment as a GT?

I’m pretty set on getting the carbon fiber QA1

According to John with QA1 regarding the 10R80, see my email with him today. He said there is nothing in the works for the Tremec at this time but expects something in the future. I did reference the GT350 since they share the same transmission and he said ford (and others) have been known to make small changes form model years and therefore wouldn’t/couldn’t say if the GT350 shaft would work

Hi Joe,

The newest model year I have listed in our new 2022 catalog is for a 2019 Mustang GT. If Steeda is installing one of our driveshafts on a ’21 Mach 1, I am not sure which one they are using, unless they had a custom one made. Steeda is one of our dealers, so they might be a good resource to see if they have put something together to use one of our carbon fiber driveshafts on the newest Mustangs. I’d check with them and see what they’re doing.



If anything else pops up though, let me know.



Thank you,



John Krueger

Technical Support & Sales

D: 952.985.6438 O: 952.985.5675 9574 217th Street West Lakeville, MN 55044 www.QA1.net

 

[JOKER M1]

Also while I was emailing John at QA1 I did talk to Phillip at STEEDA and he said they were shipping the GT 10R80 shafts for the 10R80 Mach 1’s. Phillip did seem a little confused when it came to the shafts for the Tremec

Sponsored