Jmeo
You said member ;)
- Joined
- May 28, 2014
- Threads
- 252
- Messages
- 8,772
- Reaction score
- 9,883
- Location
- Massachusetts
- First Name
- Jaime
- Vehicle(s)
- 2020 GT500, 2023 F150 Raptor
- Vehicle Showcase
- 2
- Thread starter
- #1
Ok, I am 90% done installing my Whipple 10 Rib kit and I am stuck. I was able to use a 3 arm puller to get the crank pulley off so that's good but..... The crank pulley installation kit I have will not work on this motor. Apparently I need a SPECIAL installer Rotunda OEM part # 303-1531.
I even considered (for a second) using the stick crank bolt to suck it in but the threads are at least 2.5" deep in the crank and with the pulley in place the threads of the bolt will not reach the threads in the crank.
Does anyone have any ideas. I'm thinking about going to try and find a long bolt with same thread and make my own installer but doubt I'll be able to find a bolt or threaded rod that fits OEM crank bolt thread.
Jaime
Sent from my iPhone using Tapatalk
I even considered (for a second) using the stick crank bolt to suck it in but the threads are at least 2.5" deep in the crank and with the pulley in place the threads of the bolt will not reach the threads in the crank.
Does anyone have any ideas. I'm thinking about going to try and find a long bolt with same thread and make my own installer but doubt I'll be able to find a bolt or threaded rod that fits OEM crank bolt thread.
Jaime
Sent from my iPhone using Tapatalk
Sponsored
