Can't flash back to stock

[TheHydro]

Gets guys I just installed a Whipple on my car and I am trying to install my stock tune using my SCT x4 before I load the Whipple flare tune. Every time I try and flash the stock tune the x4 shows general error# 11060. My battery is hooked up to a charger and is showing it is charged. What else can I do to get this flashed back to stock?

Sponsored

 

[Ramen]

Had the same problem with my SCT. You're going to have to call SCT and they will get you back up and running.

I sold the device and went with the ngauge immediately afterwards.

 

[TheHydro]

I just did some searching and it seems it could be a corrupt stock file. If I would have known this could have been an issue I would have never put a tune on in the first place. I guess I'll just have to wait till tomorrow to get it worked out.

 

[Jeff_oddo]

I have the nGauge and copied my stock file in the event something crazy happened to the tuning device.

 

[Rhinogt]

That's happened to many SCT tuned vehicles. SCT can set it straight but it will take you hours on the phone with them.

Sponsored