Blown S550 Dyno Power Poll

[Department Of Boost]

Now that the car has been out a year and quite a few cars have blowers I would like to conduct a poll to see what the landscape looks like.

If you have a blown S550 can you post up:

-What blower you have?

-How much boost does it make?

-What fuel are you running?

-What other engine mods (headers, off road midpipe, cat back, etc)?

-Peak HP @ what RPM?

-Peak TQ @ what RPM?

-Are your numbers standard or corrected?

And if you could post up your dyno graph that would be great.

Thanks!!!

Sponsored

 

[Burnin4]

dyno #'s are sooo subjective, really not a great indicator of true power. But, I'll play along....

Gen2 TVS, 79mm pulley/11psi, 93 octane, Kooks 1 7/8 longtubes with cats + Kooks catback, 625whp peak at 7500rpms & 535q peak at 4000rpms, Corrected, through an auto. Lund has since revised my tune, definitely making a little bit more power.

*134mph+ trap speeds on 20's.

[ame]



*566tq was a spike, pulled 535+ on 2 other pulls.

 

[Department Of Boost]

dyno #'s are sooo subjective, really not a great indicator of true power.

I more than completely agree. I'm looking for a broad picture though. Not "science".

Did you have a graph to post?

Thanks

 

[spdbydesign]

dyno #'s are sooo subjective, really not a great indicator of true power.

100%, I posted this thread recently which might have the data you seek @DepartmentOfBoost

http://www.mustang6g.com/forums/showthread.php?t=40838

 

[Barrel]

15lbs on E85. Everything else is in my sig, including the dyno sheet.

 

[BMR Tech]

This was on the stock motor and much less boost. I have never had my new combo on the Dyno, but I assume it's in the 900rwhp range.

I can say, my 900rwhp is definitely usable on the street, believe it or not. Unless under 35mph....but I have a tune that makes it work from <35mph though. ;)

-What blower you have?
VMP TVS (Gen 2) Stage 3 Kit, plus some

-How much boost does it make?
14psi for this graph / 19-20psi now.

-What fuel are you running?
E85
-What other engine mods (headers, off road midpipe, cat back, etc)?
Stock Headers, MAK Off Road pipes, Magnaflow Comp CB

-Peak HP @ what RPM?
7700

-Peak TQ @ what RPM?
4500-5700

-Are your numbers standard or corrected?
? The are SAE corrected.

Typical is SAE, STD (both corrected) or "uncorrected"

 

[Roh92cp]

This was on the stock motor and much less boost. I have never had my new combo on the Dyno, but I assume it's in the 900rwhp range.

I can say, my 900rwhp is definitely usable on the street, believe it or not. Unless under 35mph....but I have a tune that makes it work from <35mph though. ;)

-What blower you have?
VMP TVS (Gen 2) Stage 3 Kit, plus some

-How much boost does it make?
14psi for this graph / 19-20psi now.

-What fuel are you running?
E85
-What other engine mods (headers, off road midpipe, cat back, etc)?
Stock Headers, MAK Off Road pipes, Magnaflow Comp CB

-Peak HP @ what RPM?
7700

-Peak TQ @ what RPM?
4500-5700

-Are your numbers standard or corrected?
? The are SAE corrected.

Typical is SAE, STD (both corrected) or "uncorrected"

Bad ass, and thanks for the info. Are you still with stock OPG and timing gear?

 

[BMR Tech]

No. See my build thread for more specifics.

 

[smokinzx14r]

Just a little Procharger HO kit 8 PSI :( 540/460 SAE ...But it runs high 10s
Other mods ... None ...

 

[ProChargerTECH]

Just a little Procharger HO kit 8 PSI :( 540/460 SAE ...But it runs high 10s
Other mods ... None ...

Proof its not a "Dyno Queen"

Killer car man!

 

[isedawishy]

- Vortech v3 w/ stock pulley
- 93 w/ lund remote tube
- ARH full off road exhaust

Sponsored