Canarcie
Member
I don’t see any wiring pics at all, I am so new to this type posting, but ima try and search more I don’t want to tap into the wrong ones.Right on top of the sticky threads in this subforum.
Sponsored
I don’t see any wiring pics at all, I am so new to this type posting, but ima try and search more I don’t want to tap into the wrong ones.Right on top of the sticky threads in this subforum.
I read the last 30 pages of the sticky post and could not find the correct wires from the original Sub in regards to a B&O sub. I am just curious about the install, not doing this myself. I was going to initially just replace the sub speaker, then looked at adding an all in one sub/amp, but now I am trying to learn how to wire in an individual sub and amp.Yes. There’s a pinned post in this section that shows which wires are which.
What color wires did you use for those connectionsI used the high-level wires that went into the back of the sub, put them into a Audiocontrol LC2i, and then installed the Alpine 600rms amp. It sounds SO much better.
How did you set yours up if you don’t mind me asking
I was not happy with the B&O set up
With a lot of money!!!!How did you set yours up if you don’t mind me asking
How did you set yours up if you don’t mind me asking
If only I had more money to do things right…beautiful looking setup! Im sure it sounds amazing.Went with 3 of JL Audios VXi line amplifiers with built in DSP's,
2x 800/8
1x 1000/1
Hertz Audio Mille Legends 3 way components running Active in the front and Hertz Legends to 2 way components in the rear
2 of JL 12" TW3 Subs
How was your amp Powered ?did you tap into you stock sub for signalsWent with 3 of JL Audios VXi line amplifiers with built in DSP's,
2x 800/8
1x 1000/1
Hertz Audio Mille Legends 3 way components running Active in the front and Hertz Legends to 2 way components in the rear
2 of JL 12" TW3 Subs
All the Speakers are install in the stock spots for a very clean look. The Trunk was a lot of custom fab to give that clean built in look.
It was all off of the head unit.How was your amp Powered ?did you tap into you stock sub for signals
I don’t see any wiring pics at all, I am so new to this type posting, but ima try and search more I don’t want to tap into the wrong ones.
Great so these are the inputs for my Lc2pro for SignalI went back to Feb 21 and found where I posted the correct wires from the subwoofer. Here is that post.
"I used the green and yellow (both are +) and black and purple (both are -) and ran them to the input on the JL amp. In your case, this would be going to the new subwoofer".
Keep in mind, this guy was wiring a new sub without a new amp.......so just key on my first sentence.
Man I appreciate it a lot !!!!Yes those are the inputs to your LC2Pro to grab the signal.