Anyone replace a rear lower control arm spherical bearing.

[Fusion Training Systems]

Months ago I had the Steeda rear lower control arm spherical bearing put in and can’t take the NVH anymore.

Going to replace it with Steeda’s polyurethane bushings that’s a step up from OEM but causes much less clunking….

Has anyone done this without having to replace the rear lower control arm and the new poly bushing stayed intact?

Thanks

Sponsored

 

[Ramairetransam]

did you ever swap to the poly

 

[Fusion Training Systems]

did you ever swap to the poly

Yes I did. Much much better….

 

[GrabberBargeCaptain]

Are the poly's quiet or do they still make a bit of noise?

 

[Fusion Training Systems]

Much quieter…..

 

[Mustangcol]

Months ago I had the Steeda rear lower control arm spherical bearing put in and can’t take the NVH anymore.

Going to replace it with Steeda’s polyurethane bushings that’s a step up from OEM but causes much less clunking….

Has anyone done this without having to replace the rear lower control arm and the new poly bushing stayed intact?

Thanks

I installed the BMR bearings in November 2024, 7,000km on them, on crappy colombian roads, always heavy rain, and I didn't notice any NVH, I had installed lots of other mods at the same time. They're in my signature

 

[NightmareMoon]

You get noise when you close the loop and connect all the parts without rubber. People blame the last part they inatalled but its all of them. I just did spherical mains and the toe link and no noise. Added the bushings and cradle reinforcements and boom, NVH. Any of those by themselves would still be isolated by rubber in other places.

Sponsored