Steeda CAI Review and Install Notes:

[Knight5.0]

It's over. lol



:cheers:

Haha. Yeah. 7 to 29 Alabama


Sent from my iPhone using Tapatalk

Sponsored

 

[Knight5.0]

Man I hate sitting my hood by push hard with my hands. I usually grab my hood latch pull it down hard and let it go. Feel like I'm gonna dent my hood pushing down on it. Not to mention two big hand prints. Hhmmmm. It should get easier with time as it compresses the hood liner in the areas the box makes contact.


Sent from my iPhone using Tapatalk

 

[ifly680g]

Man I hate sitting my hood by push hard with my hands. I usually grab my hood latch pull it down hard and let it go. Feel like I'm gonna dent my hood pushing down on it. Not to mention two big hand prints. Hhmmmm. It should get easier with time as it compresses the hood liner in the areas the box makes contact.


Sent from my iPhone using Tapatalk

Just installed mine today, the hood closes no problem seems like it fits good.

 

[ifly680g]

Just installed mine today, the hood closes no problem seems like it fits good.

Here is a pic.

 

[nrothaar]

Currently installing my Intake but the screws for installing the MAF sensor don't seem to fit... Did anyone else have this problem??

 

[ifly680g]

Currently installing my Intake but the screws for installing the MAF sensor don't seem to fit... Did anyone else have this problem??

The screws for the MAF that Steeda provided fit perfectly.

Don't use your old screws!!

 

[nrothaar]

The screws for the MAF that Steeda provided fit perfectly.

Don't use your old screws!!

The screws Steeda provided me won't even go through the MAF holes take a look

http://imgur.com/txbfWsF

 

[svtfever]

how did you guys get your steeda sticker to stick. my box is too slippery for it to stick

 

[stoli]

how did you guys get your steeda sticker to stick. my box is too slippery for it to stick

You'd have to clean it with alcohol or some other apc.

 

[SLA]

how did you guys get your steeda sticker to stick. my box is too slippery for it to stick

I cleaned the inside off. Of course I wasn't smart enough to do that first so I still had a little bit of trouble getting one side to stick.

 

[Knight5.0]

Just installed mine today, the hood closes no problem seems like it fits good.

It closes no problem but I have to push hard on the hood to close it. I can tell the seal on the box is pressing on the hood a little. A


Sent from my iPhone using Tapatalk

 

['Merica]

The screws Steeda provided me won't even go through the MAF holes take a look

http://imgur.com/txbfWsF

I reused the stock screws. I actually didn't realize Steeda provided screws until the install was complete. The stock screws worked perfectly for me.

 

[Sasuketr]

I reused the stock screws. I actually didn't realize Steeda provided screws until the install was complete. The stock screws worked perfectly for me.

Same here, used the stock screws even for the very last bottom hole for the box itself!

 

[Sasuketr]

The IAT's do look high at idle! My seal was a pain in the ass to put on! I m still not sure if its sealed completely.

 

['Merica]

I had the seal on in less than 2 minutes, where are you guys running into trouble on it? The biggest pain of the install for me was using a handsaw to get the resonator thing off the intake piece you reuse. Overall, I couldn't believe how simple the install was.

Sponsored