Procharger Stage 2 Install

[emh87]

I listened to the proflow compared to the bullet open on YouTube, guy did a cool comparison with his gopro and you can tell the difference. Bullet is much louder. Performance wise I don't know. Procharger is for out of stock on the closed ones, which I would likely do, because I would throw a filter on it to muffle that thing some. I don't like advertising that my cars blown,I like the surprise factor.

Tapatalk spelling errors inside!

Could you link said video?

Sponsored

 

[Process]

Theres a big red for sale locally never used for $275.

 

[Phils15GT]

I am going to keep the Big red in hopes of someone creating an intake that fits nicely. Loud!!! No masking the sound of a D1SC so I figured why not toss the loud bypass on there. Sounds nasty!

 

[Nemesys]

I should have the revised inlet from PC today, Ill take a few pics.

 

[Barrel]

I'm picking up car tomorrow assuming nothing else happens. I'll snap some photos of the rerouting and new inlet.

 

[gqneon]

Could you link said video?

[ame]

Here ya go.

 

[Nemesys]

Here is the updated inlet from PC. Suffice it to say, its going to require some modification to fit in there. It extends out further than the regular one.

 

[gqneon]

Here is the updated inlet from PC. Suffice it to say, its going to require some modification to fit in there. It extends out further than the regular one.

Uhh.... yeah. Did they just send you an elbow to do their R&D or what? Can you tell me what the ID size is on both ends if you get a minute? I'm curious.

 

[Sam@Coastal]

Here is the updated inlet from PC. Suffice it to say, its going to require some modification to fit in there. It extends out further than the regular one.

Trust me from experience, just get that 3.5 hard plastic 90 and trim it to fit. It will fit 10 times better and leave you more room up there.

 

[gqneon]

Sam do you mean the air raid 3.5" elbow?

Tapatalk spelling errors inside!

 

[Nemesys]

I was able to trim the updated inlet, and the valve doesnt push hard against it. Ill report back to see what happens when I pull to 7k

 

[Sam@Coastal]

Sam do you mean the air raid 3.5" elbow?

Tapatalk spelling errors inside!

yes, thats what we use here in the shop

 

[gqneon]

I was able to trim the updated inlet, and the valve doesnt push hard against it. Ill report back to see what happens when I pull to 7k

I'm excited to see if the replacement part works. If so, it might be part of a few of our problems with top end power being squashed. I don't think mines flattening out completely but it is possible it's constricting and necking down the power up high. 486 torque just isn't right and assuming they send these to customers who have the stage 2 kits like us it might help correct that. Hard plastic makes so much more sense in this situation even though the silicone rubber was an easy one size sort of fits all approach. I looked at the Vortech intakes and you talk about night and day ...

Tapatalk spelling errors inside!

 

[gqneon]

If I could pop my intake off for a run I would, but if never get out back on afterwards, hence my reservation since the stock kit hose was never sized for the inlet.

Tapatalk spelling errors inside!

 

[z06psi]

Here is the updated inlet from PC. Suffice it to say, its going to require some modification to fit in there. It extends out further than the regular one.

That first 1.5" to 2.5" could be cutoff on the right. That will put it closer to the head unit.

Sponsored