ESS Centrifugal Mustang Superchargers

[Mikepol2]

I never picked up any silicone spray or anything recommended to make the piping easier. Safe to say I’m fed up with them and the clamps now! Lol

A little dish soap in water works just fine.

Sponsored

 

[SheepDog]

I never picked up any silicone spray or anything recommended to make the piping easier. Safe to say I’m fed up with them and the clamps now! Lol

I like to use a bit of glass cleaner when I'm fucking around with those tubes. Helps everything go together easily, and dries with no residue

 

[Pistol_91]

Spit on that thang. The only way it will work if you twist that shit as hard as you can and use every cuss word you have in your inventory. Lol good luck.

 

[tritonx]

Got it, appreciate you guys. My bad if my questions are annoyng and obvious, before this install I could only name like 4 parts in my engine bay lol

 

[Mach VII]

Got it, appreciate you guys. My bad if my questions are annoyng and obvious, before this install I could only name like 4 parts in my engine bay lol

You looking for side work? Plenty of dealerships are hiring lol

 

[tritonx]

You looking for side work? Plenty of dealerships are hiring lol

Lol I’d probably take a huge pay cut compared to my current job. But it would be sick to spend some time as a ford mechanic to learn things over, and I’m sure i fk up my car just as bad as they do

 

[Pistol_91]

Dude it's all good that's why this thread exist. Lol it's actually impressive that you're doing all this with your level of experience. There's some nancy's on here that dont know how or refuse to even check their dipstick.

 

[JTM88]

Hairspray works good for couplings, and dries sticky.

 

[Bob Lob Law]

I found squeeze the silicon tubing while twisting it back and forth as you're feeding it through the tight spots made it quick and easy without damaging the tube.

 

[wingnutt]

Hairspray works good for couplings, and dries sticky.

this times eleventy…but hairspray has kinda gone outa style nowadays

 

[tritonx]

If anyones awake… would you guys say my air filter is in the right spot or does it need to get more inward for clearance??? Couldnt find a good pic of where its supposed to sit.

 

[tritonx]

Update: still got a lot to check and do tomorrow (pump booster, oil changs, reassembly) but i just gave it a start up today with permission from my tuner and everything fired up perfectly!

 

[Pistol_91]

Air filter looks fine it just needs to clear the horn. I would be sure to make plenty of room for the filter while you have the bumper off. When you'll need to do an air filter change in the future, it will be a lot easier if you make the room now.

 

[Mikepol2]

If anyones awake… would you guys say my air filter is in the right spot or does it need to get more inward for clearance??? Couldnt find a good pic of where its supposed to sit.

Holy crap, your filter is HUGE compared to mine. There's an oil cooler there on Mach's so there's only room for a filter about 2/3 as long as that, and even so you need a sledgehammer to wedge it in there.

 

[pinksurfer]

Air filter looks fine it just needs to clear the horn. I would be sure to make plenty of room for the filter while you have the bumper off. When you'll need to do an air filter change in the future, it will be a lot easier if you make the room now.

do you have to remove the front bumper to change it or can you pull back the wheel well or lower panel to change?

Sponsored