What did you do to your Mach 1 today

[Pipefittermax]

first tank of E85

Nice exhaust tips!

Sponsored

 

[Pipefittermax]

Car is finally out of storage, put the oil temp sensor in.

 

[skinnyb]

Car is finally out of storage, put the oil temp sensor in.

One of the best mods I did, and easiest

 

[greasy]

Got these bad boys installed, hopefully they save what's left of my paint.

Save what’s left of your paint?

You sure you are going to get $85K for an unoriginal White Mach 1 with paint issues? Moron

 

[RacerMach1]

Save what’s left of your paint?

You sure you are going to get $85K for an unoriginal White Mach 1 with paint issues? Moron

You are so mad, so everyone knows Greasy owns a fake Mach 1 that I called out for having fake badges (upbadged ecoboost) he is now going thru all my posts since his triggered.

 

[greasy]

You are so mad, so everyone knows Greasy owns a fake Mach 1 that I called out for having fake badges (upbadged ecoboost) he is now going thru all my posts since his triggered.

Yup!!!

 

[Mikepol2]

Won my first award of the car show season

 

[Mikepol2]

Took @gorditas advice and drilled out the 23 plastic rivets holding on the HP splitter and replaced them with 10–24 rivnuts.

A couple tips:

MARK THE HOLES THAT GET THE 10 FACTORY 7mm HEX SCREWS. It’s really hard to tell which ones they go in when all the rivets are drilled out.

Make sure you order stainless steel fasteners.

Just thread the rivnut far enough onto the mandrel to engage all the threads in the rivnut, it will make squeezing the tool easier.

I used 1 inch long button head screws with washers, but should have used regular hex head screws. Too cumbersome trying to use an Allen wrench in there.

Used a quarter inch center drill to remove the old rivets.

if you get the style of tool that requires you to squeeze to handles together, be prepared, takes a lot of grip strength.

Make sure the screws turn in easily before attempting any powered installation. If they get wedged, they will just spin the rivnut in the plastic hole and you will never get it back out.

 

[Jimmy Dean]

Removed carbon filter. Have not driven it, don't really expect to notice any difference via the ole butt dyno though.

 

[First Stang]

Took er to Mustang Week TX. Counted Mach 1’s in attendance.

 

[Dler]

Installed the Boss 302 side exhaust. I absolutely love the way it sounds (Growl)

 

[Trap]

It adds a nice tone to it.

 

[Dler]

It adds a nice tone to it.

It sure does

 

[Jimmy Dean]

It sure does

what did you do on the back end valence? just leave it empty?

 

[Dler]

what did you do on the back end valence? just leave it empty?

It’s still there. This kit adds side exit exhaust to the original exhaust system.

Sponsored