What did you do to your S550 Mustang today?!

[Nagare]

Added a Drake Muscle Car strut brace to my 2 week old, 2019 GT Premium. I actually installed it on Thanksgiving Morning.

Looks great on there!

Sponsored

 

[Hudman]

Looks great on there!

Thanks!

 

[JOKER M1]

Did the Chemical Guys Glass Workz Glaze, officially ready to sit for 4 months

 

[Sawyerjames]

Went to see my boy for a wash

 

[rum_punch_ruby]

Did the Chemical Guys Glass Workz Glaze, officially ready to sit for 4 months

Gorgeous!

 

[JOKER M1]

I do drink a lot of coffee in the garage for sure

 

[Sig556]

Finally got around to installing my front fender side scoops. What a PITA to get the color close. These were done twice as there are at least 5 shades of Oxford White. Over all they don't look too bad and give a real performance look to the car.

 

[Cobrajet21]

Installed new shifter ball.

 

[Ecoboosted]

Did the Chemical Guys Glass Workz Glaze, officially ready to sit for 4 months

Yea I did the same thing on my DD, Mustang and Street Glide within 3 weeks of each other. Started of with a good wash then clay bar then glaze then Jet Seal and top it off with a good wax.

 

[Sig556]

Added a Drake Muscle Car strut brace to my 2 week old, 2019 GT Premium. I actually installed it on Thanksgiving Morning.

I actually like this better than the stock Ford Gt Brace.

 

[VooDooDaddy]

Painted the front calipers with POR 15. Looks like powder-coating.

Put a coat of Nano Bond 9H ceramic on it, hooked it up to the battery tender, then put it away for about the next 5 months...

 

[sy1462]

Finally got some time off to install sp083’s, ford track dampers, BMR vertical links and cradle lockout. Only had them since April lol. Install wasn’t bad at all... would have been easier if I looked at the CJ Pony rear spring install video first... was a breeze after lowering the cradle. Weather turned bad here but stance looks good. Was worried about the front drop with the added weight of the supercharger but it looks ok. Hope it drives as good as it looks.

 

[MasterCylinder]

Replaced my non-PP GT rear shocks with PP GT rear shocks. Instant noticeable difference in stiffness.

 

[JOKER M1]

Painted the front calipers with POR 15. Looks like powder-coating.

Put a coat of Nano Bond 9H ceramic on it, hooked it up to the battery tender, then put it away for about the next 5 months...

Looks nice, POR-15 is a great product. I’ve used it on engine blocks, under bodies, drivetrain etc.

Sponsored