Getdownonit
Well-Known Member
Here's my setup from Sam @ Coastal Dyno.^ yup this! The challenge with the PC set up is if you use stock routing with the hotside pipe you have to be creative with the placement of the BOV and WG. Coastal has a bad @ss set up where the pipe wraps around the wheel well but it looks like you cannot have an intake with the pipe set up like that so you are left with an open blower intake.
Either way, I ordered a hotside pipe from Travis at Boostworks to relocate the race valve to the front and since the WG is smaller I should be able to fit it on the pipe where the race valve used to be.
WG will be here Tuesday, once the pipe comes in from Travis I will document and post the whole thing for other PC guys.
Sponsored