Window adjustment?

[IPOGT]

Guys,


Question, My driver window needs to move back toward the 1/4 window about an 1/8" in order to set in the seal tighter. Anyone remove the door panel and adjust this?

Sponsored

 

[kapiteinlangzaam]

I would love to know the answer to this as well.

My drivers window has been 'off' since new, sealing nowhere near as good as the passenger side.

I can hear it already at 70mph, and by 130mph its like a bloody hurricane.

Been to the dealer twice, they deny the problem exists.....

 

[wireeater]

I would love to know the answer to this as well.

My drivers window has been 'off' since new, sealing nowhere near as good as the passenger side.

I can hear it already at 70mph, and by 130mph its like a bloody hurricane.

Been to the dealer twice, they deny the problem exists.....

Probably because they don't want to go to 130 MPH to replicate the issue.:lol:

 

[kapiteinlangzaam]

Probably because they don't want to go to 130 MPH to replicate the issue.:lol:

You can hear it at 70mph too.

I've shown them videos at 130-170mph.... They don't deny it exists, but just like every Mustang problem in Europe, they've no clue how to fix it :(

 

[IPOGT]

On mine the gap between the1/4 window and the driver window is double the passenger side and the window shakes when I open the door whereas the passenger side is fine. I believe it's from the lack of contact with the seal.

 

[IPOGT]

How can anyone deny a problem exists when your LOOKING at it?

 

[Marvinmadman]

This shouldn't be too hard to fix. Remove door panel/card. Remove moisture barrier. Find the glass clamps. Loosen and slide the glass the way you want it and profit. Unless the s550 has a weird design. I haven't looked at it yet.

 

[IPOGT]

Thanks for the input. Not thinking it’s too hard to do, but it would be nice NOT to experiment on my car If you know what I mean.
Also, I know that some of these mechanisms can have various interactive parts which can be a pain to align without 4 hands and a table.

 

[x_man586]

When you loosen the bolts that hold the glass it drops an inch or so. You lose a point of reference for how the glass sat. It is trial and error to get it just right.

Sponsored