What did you do to your GT350 today?

[Darth Cobra]

Another pic...

Sponsored

 

[Darth Cobra]

That's cool. How did you install it?

It's just friction fit. Press in the crack. The vinyl piping has a "tab" that is slotted every 1/8" or so. Real easy. A couple of the tight spots just lifted the panel slightly to wedge it in. EBay seller has a bunch of colors.

 

[zombiekiller]

Installed my mgw shift ( finally).

Finished up all of the plumbing on my trans cooler.

Tomorrow will be carbon fiber driveshaft install, wiring, and reassembly.

 

[crazymayhem]

didnt drive her, but got around to checking the dip stick. After 950 smiles the oil level is maybe 1/8th or so above the lower circle. I think im good on oil....

 

[EF300]

didnt drive her, but got around to checking the dip stick. After 950 smiles the oil level is maybe 1/8th or so above the lower circle. I think im good on oil....

My dip stick results are all over the place . Seems it reads different every time I check it. Maybe its my technique

 

[crazymayhem]

I didnt have an issue. pulled it out, wiped it clean, and back in it went. Tried it 3 times, and it was in the same spot every time.

Damn... re-reading that... sounds just raunchy...

 

[honeybadger]

I installed my Space City Heel Toe Spacers. Won't get to drive it until Saturday, but it feels MUCH better already. Much easier to dab the throttle.

Still thinking about SRP pedals down the road tho. Stock pedals are a bit slippery when wet. Will wait until I get a few track days down before deciding to drop the $130.

 

[RR350]

Put in a dash cam.

 

[montreal ponies]

Put her on jackstands and will be swapping trans and diff oil this week-end using MG syncroshiftII and Motorcraft diff oil. Then back to hibernating. :(

 

[Readfast]

Put her on jackstands and will be swapping trans and diff oil this week-end using MG syncroshiftII and Motorcraft diff oil. Then back to hibernating. :(

Sounds Like Fun!!!!:doh: NOT!

Good Luck!!!!

 

[RR350]

Drove it to work Also hit 5k miles today

 

[unixadm]

I had more parts for the car show up today. Steeda jacking rails, Steeda 2-point brace and I also got four new aluminum Torin jack stands along with a new Sunex 2 Ton lowrider 24" lift jack. I shouldn't have any issues with the GT350 now. I've wanted a new low profile jack for a while and the GT350 just pushed me over the edge.

 

[Readfast]

Got my jacking rails Monday and thought I was good to go.
Nope my jack is probably a 1/4" to high. Damn now I got to go buy a jack or take the plunge and buy the lift I've been holding off on buying!

My wife is going to kill me either way. Tells me I love the car more than her. Which is true some days. Lol

Might as well take the plunge and get the lift. I'm dead either way!

 

[Stage_3]

Man that is GORGEOUS!!!

 

[Steve68]

Got my jacking rails Monday and thought I was good to go.
Nope my jack is probably a 1/4" to high. Damn now I got to go buy a jack or take the plunge and buy the lift I've been holding off on buying!

My wife is going to kill me either way. Tells me I love the car more than her. Which is true some days. Lol

Might as well take the plunge and get the lift. I'm dead either way!

What she doesn't know won't hurt you.

Sponsored